How Do You Install a Front License Plate Without Damaging Your ...

Yes. You put it on with the plate bracket attached for positioning purposes and then you remove the plate bracket and leave just the mounting ...

This is a simple procedure that should work for most cars though it'll vary depending on the type of bracket your car uses.

The screws that hold the plate mount drill directly into the bumper, so if you don't want holes in your bumper, make sure to let your ...

The holes that are required for the self tapping screws are located BEHIND the aero cover. The ugly license plate bracket that GM supplies is ...

No drill License Plate Brackets holder mount relocator for Cars, Trucks and SUV's. ACURA, AUDI, BMW, CADILLAC, DODGE, HONDA, MERCEDES...

In the front bumper, between the upper and lower grill, there's two very small dimples (spaced the width of the holes in your license plate), ...

The screws just screw directly into the bumper, which in my opinion is CHEAP! They could have at least made covered threaded holes, with a plug ...

Any parts store will have the plastic inserts that you push into those square holes then you attach the plate with screws into the screw holes ...

I just drilled two extra holes in the stock License plate holder then ran zip ties thru the holes and thru the lower grill. tightened them and ...

Here's how I installed my front license plate using the Lexus OEM front license plate mount without drilling holes into my bumper. The Lexus OEM ...

The easiest solution for me was some 4” toggle bolts. I drilled 4 holes thru a license plate frame (2 on each side) and inserted the toggle ...

If there were a way to mount some very strong magnets just on the inside of the bumper, then you could attach magnets to a licens plate frame ...

Don't attach it to the grill, the radiator needs the airflow. There may be some way, but screws are the most reliable way of holding a license ...

I already got bumper plugs but put the license plate holder back on once I saw there was the screw damage (again not the 4 plate holes) on the ...

2 way taping the plate holder to the grille will not damage it. You don't have to drill any holes and it can be removed. However the sto n sho ...

Hi guys, Anyone have a lead on options for no drill/ no glue license plates for the front of the Macan EV...magnetic or otherwise?

Use the 3 black self-tapping screws on your picture and drive them through each of those holes, being careful not to over-tighten them. Then ...

Yes, we require it as well. I purchased mine in Illinois and they don't require front plates. Ha. I know it. Drilling into the front of a brand ...

Ideally, there is nothing immediately behind the plastic central radiator opening and I can just use four screws to mount the plate. Most likely ...

I just removed my front license plate from my car and filled in the holes with Bumper Plugs. It worked really well. In fact, the process was ...