Events2Join

safe to drive with cam phaser knock


Cam phasers ticking? I have a permanent fix. - Ford F150 Forum

This is supposed to keep the cam timing from bouncing all over the place at idle, which would cause major ticking and knocking noises as well as ...

Ford Triton V8 Cam Phaser Knock - How To Fix It

You look around to try and figure out whose car is about to blow up — and to your dread, that noise is coming from your engine! Most likely, if you notice an in ...

2005 4.6 cam phaser noise - MustangForums.com

It'll be OK for now but it's only a matter of time before it gets worse, and there's always the small risk of sudden failure. Better to replace ...

Ford F150 5.4L 3v cam phasers - The Combine Forum

decent looking truck... and it runs like a dream...... until you drive it for 10 min then it will start rumbling and missing nearly stalling ...

Ford 4.6l 3v & 5.4L 3v Camshaft Phaser Knocking Noise Fix - YouTube

This video saved me hours of headache, by actually having the noise the engine makes when having this issue. It's the exact noise mine is making.

Powerboost Rattle - Cam Phasers When Switching from Electric to ...

Is it possible that you hear the cam phaser rattle when the truck fires up and switches from electric to gas driving? ... OK, I think this ...

Victim of the cam phaser issue - Bronco Nation

... knocking sound at cold start, the car drive normal. Ok, sounds like you caught it before potentially serious damage - Good on ya! Cheers. PB.

Article: Cam Phaser Issue Explained | Ranger6G - Ranger6G

By adjusting the position of the camshaft in relation to the crankshaft, cam phasers can alter the valve timing to suit different driving ...

Used F150... cam phasers? - Off-Ramp - FORUM | LEASEHACKR

My concern here is that Ford's official position is “it's just a noise, no need to replace them under warranty” even though there have been many ...

2018 Ford F150 3.5L Cam Phaser noise - Diagnostic Network

After the repair the truck started like normal with no timing chain rattle. When the truck is up to temperature and you start the engine it will cycle the ...

Cam Phasers | McLaren Life

The good news is the faulty phasers are sorted out, which is a big deal of a repair. I would rather buy a car with cam phasers fixed then run into that issue ...

Thread: F150 5.4L issues? Cam phaser problem on 2010's?

It's more of a light knock you are listening for. If you ... I've been trying to decide if I want to sell mine or drive it until it dies.

2018 Nav engine knocking at start-up | Page 2 - Lincoln Forums

At 80K and 2 years, the cam phaser rattle returned louder than before. ... I just took the car to dealer for cam phaser recall and reprogram.

cam phaser rattel - Lincoln Navigator Forum - Blue Oval Forums

On 3/13/2020 at 11:46 PM, Black Label said: The video in my first response in post #2 was talking about that. Either that or the cam phasers or ...

Dealer sent me home with Cam Phaser rattle - Bronco6G

Good news is that it does not seem to be a wear issue and driving the vehicle with the cam phaser issue does not appear to be causing "other" ...

5.4L 3v Camshaft Phaser Knock Noise Fix - Ford Forums

In this video I go over in detail the procedure to swap out the Cam Phaser to get rid of that annoying knocking noise at idle! It is easier than you think.

Cam phaser ticking solution strategies? - Ford Mustang Forum

The phaser knock is not only caused by oil pressure but a poor design of the early phasers that Ford installed. They were re-designed I believe in '08 to be a ...

Cam Phaser Replacement Costs - F150online Forums

... noise, what are the results of driving around with bad cam phasers? ... phasers, oil pump, oil pan front and rear seals ran ok. Than two ...

Ford F150 3.5 Ecoboost cam phasers to fix now or later

My truck started to make 2 days ago the awfull cold start up noise well documented on various board. Ok that happen only once but hey i dont ...

Should I Change Just One Phaser? - S197Forum.com

I have narrowed a noise (knock) coming from the passenger side of my engine down to a bad cam phaser. (light knock at idle, hot or cold, ...