8.8 inch type|c problem
Chryco 8.25 vs. Ford 8.8 - MJ Tech - Comanche Club Forums
An 8.8 is stronger than a Dana 44, you can run 40s on an 8.8 without problems. Plus the discs! C'mon, hands down. I just bought one with 4.10s ...
Oil type for Ford 8.8 with Limited-Slip? - Grassroots Motorsports
If it is a problem on the street, then that is just a sign that you should be using an open diff and not something that compromises drivability.
Alxe end play on 8.8 soild rear? - Factory Five Racing Forum
If yours float, then no problem as per the above responce. FYI I believe Ford sells different thickness c-clips and some play can be taken out ...
Ford 8.8 | For FMJ Bodies Only
And while this video isn't specific to our cars, it points out a potential solution for the U joint problem...
Rear axle build---options on 8.8" and 8.8" vs 9" | SVTPerformance.com
I had ford nine inch ends welded on with Moser 33 spline axles and a Moser wave trac. ... The problem with the 9" housing is it will bolt in but ...
[WIP] Upgrading 8.8" screen to 10.25" - G20 BMW 3-Series Forum
Now the fundamental problem is that the MGU screen resolution ... On the larger screen, the right side of it ends at the end of the right a/c vent lever.
Ford 9 inch & 8.8 and 12 bolt users please advise - ThirdGen.Org
If you use the tapered roller bearings it's not a problem, but if ... My factory 9 bolt has the tapered bearings and no c clips. If it ...
lift gained by 8.8 swap - Jeep Wrangler Forum
one inch i think wil be to much and lift me in the other direction ... Rubi 44 front, w 4.88, Artec Industies truss, Inner c braces, Eaton E- ...
A-Body Rear Swap - 8.8 Ford Explorer - Moparts Forums
1996 explorer 8.8, came with posi, 3.73 gears, disc brakes, 31 spline axles, thick axle tubes,3 1/4 inch dia. It is 59.5 wide, but will work under a stock A ...
Should i get a dana 44 or a Ford 8.8 - Jeep Cherokee Forum
The drawbacks are the c-clips and weak factory carrier. Weld the tubes to the housing since they like to spin. It's also about an inch narrower ...
biggest tire for a 8.8 | NAXJA Forums - North American XJ Association
The snapped axle shafts held in all the way out, with just the calipers to retain them......C clips, I laugh, they are no problem with disc ...
Ford Explorer 8.8 rear axle interesting information | Turbobricks
5 inches. The weakest links are the plug welds that hold the ... I don't think the c-clip downside is much of a problem, though. Any ...
Rear axle swap ? Consider the Ford 8.8 | Page 2 - Jeep-CJ.com
For comparison, my TJ with MTR 37's on 61 inch wide axles and 17x9 rims 4 inch backspacing M/T classic II's. ... Problem with the C-clip ...
Head Unit Bricked during BMW Recall - 8.8 Screen Upgrade
Yes I did think that and when they called me to say it had failed I told them to change the display setting to an 8.8 inch screen but it didn't ...
Ford 8.8 shorten or not? | S-10 Forum
If you don't narrow the 8.8 then the pinion is going to be offset a few inches. This may not be a problem in your case, but in some cars it ...
8.8” screen retrofit for ENTRYNAV | Mini Cooper Forum
Apparently others have had this problem when using BimmerCode. ... Received my 8.8 inch screen this morning, got it installed and coded using ...
Ford 8.8 Axle Boot Clearance Issues - Solved? [Archive] - Miata Forum
After having this problem creep up on my car ('91 BRG w/302), I sent the half-shafts to A-1 Driveshaft in Milwaukee. They cleaned, greased, ...
My 8.8 rear axle build/swap | Chevy Nova Forum
Ran into my first problem. c-clip eliminators for the stock 31 spline axles do not exist. You can get them for rustang axles but not exploders.
Fairlane Owners/Enthusiasts :: Leaf Spring/8.8 Inch Rear Questions
Ok, I think I've found my problem with getting the 8.8 bolted in. ... Steve 64 S/C big brakes 8.8 rear 289 lentech AOD, strut front suspension.
Pros/Cons of 12 bolt/9 inch/8.8 inch - LS1Tech.com
What are the (unbiased) pro's/con's of each different type of rear end as far as reliability, strength, possible problems, cost, etc. Thanks ...