How to remove stuck rotors

How To Remove Stuck Brake Rotor - YouTube

PB Blaster .............................................. https://amzn.to/4dIfVgn WD-40 Penetrant ...

3lb sledge and hit rotor hat around in circle. Somtimes have to put some heat/pentrating oil as well. Rubber mallet.

Stuck rotors - bolt size to help remove them - LegacyGT.com

The 2 small threaded holes in the rotors are to help you get them off. Basically, you screw in a bolt until it separates the rotor from the mount.

Any tips for getting brake rotors off, Please. | SVTPerformance.com

Big hammer on the face of the rotor. This will allow the most power to shock the rotors loose. Also if you have an air hammer that will be real easy.

Seized I can't remove the Brake Rotor | Toyota Tundra Forums

A few good whacks with a regular sledge hammer will usually free up the rust on the back of the rotor thats seizing it to the hub assembly.

Brake Rotor Stuck To Hub Advice / Help - Hyundai Forums

often its just rust holding them on. here is some advice on removing stuck rotors: method 1: this is why i keep a 2x4 that is about 12" long in ...

Stuck Rotors? - Land Rover Forums

Remember to take out the big phillips screw that screws the rotor to the hub, they are so freakin soft so be careful with them, once you get ...

Removing Stuck Brake Rotors | EricTheCarGuy

If you've ever found yourself looking for an even bigger BFH to remove stubborn brake rotors you may have a use for the video below: http://www.youtube.com/

A better way to remove stuck brake rotors - Ford Truck Enthusiasts

1997 - 2006 Expedition & Navigator - A better way to remove stuck brake rotors - YouTube - Remove Ford Truck Brake Rotors ...

Rotors stuck won't come off | Drive Accord Honda Forums

The rust has seized the rotor on the hub, try hammering the hub of the rotor with a sledge hammer to break the rust bond. There are also two ...

Stuck brake rotors | BobIsTheOilGuy

Tap the back side, rotate 90 degrees and tap again. Keep tapping and rotating, maybe increase the tapping force and the rotor should come off.

Stuck on Brake Rotors - Ford Taurus Forum

The rust has bonded the rotor to the hub. If you bang on the rotor, you will bend it and you will have to replace it. Try applying heat with a ...

Trick to remove stuck rotor - Jeep Forum

Remove the caliper and thread the bolts into the caliper bracket holes from the back. Thread the nut on after the bolt is through the bracket ...

Rotor Removal Stuck?? - EvolutionM - Mitsubishi Lancer and Lancer ...

There are 6 holes in the rear rotors 5 for the wheel studs and one threaded hole for the extractor bolt. Any metric bolt 8m x 1 - 1 1/2"long with the correct ...

Effective Methods for Getting a Stuck Rotor Off - Dodge - JustAnswer

How to remove rotor from grand caravan 2008 tried dw40 heat and hammer.

How to remove rusted and seized brake discs / rotors on the CRV

How to remove rusted and seized brake discs / rotors on the CRV · Gentle (and not so gentle) tapping around the brake disc edge with a soft face ...

Remove stuck brake rotor, weird bolt size issue - Honda-Tech

The right bolt (M8 x 1.25) definitely does not fit those holes. It starts to thread and then jams, like the thread pitch is wrong.

Removing Seized Rear Brake Rotors - Sprinter-Source.com

I am trying to remove the old rear rotors, I have removed the torx screw, have saturated in WD-40 and tapped around it with a hammer. Not budging.

Removing stuck rotors - Maxima Forums

IIRC the size is M8x1.25. I doubt you will need them. Brake drums commonly stick and need "persuasion" to come off. Rotors are usually easy to ...

Stuck Rotors | BimmerFest BMW Forum

With the car properly supported on jackstand, place a piece of wood between the floor jack and the rotor and jack the rotor up a bit. It will ...