IPv6 Default Gateway in Static routes

How to set a static IPv6 default route with dhcpcd?

3 Answers 3 ... You cannot use DHCPv4 to give out default IPv6 routes. You cannot even use DHCPv6 to give out default IPv6 routes. The reason is ...

Configure a Static Route - Palo Alto Networks

Select NetworkVirtual Router and select the virtual router you are configuring, such as default. · Select the Static Routes tab. · Select IPv4 or IPv6, depending ...

Chapter 26. Configuring a static route - Red Hat Documentation

2.0/24 ). Router 2 sends the traffic to Router 1 because of the default gateway settings. The actual behavior of Router 1 depends on the rp_filter sysctl ...

How to add IPv6 static route via host on other network? - Super User

Routes work by altering the link-layer address of packets, and those by definition are only possible to set within the local network – as soon ...

FE80::1 is a Perfectly Valid IPv6 Default Gateway Address

Typically, link-local IPv6 addresses have “FE80” as the hexadecimal representation of the first 10 bits of the 128-bit IPv6 address.

How to configure IPv6 Static Route - YouTube

https://nwl.cl/2fNnYx9 - IPv6 static routes examples for prefixes, default routes, host routes and floating routes using outgoing interfaces ...

Configuring static routes - IBM

Procedure · In the IPv6 Default Gateway field, specify an address value. For example: 2001:0DB8:0000:0000:02AB:00FF:FE29:9C6A . · Click Save.

[SOLVED] No IPv6 default route in main routing table - OpenWrt Forum

Can you show us this information? e.g.. I don't see a "wan6_cable" interface; I don't see configs for the static routes you mentioned; I don ...

How to add static ipv6 route with systemd-networkd

This way the first block adds a default IPv6 routing entry, equivalent to ip -6 route add default via fe80::1 proto static. If you for ...

RS0036 - IPv6 Default Preference and Static Route

The video looks further into mechanism that IPv6 uses to provide default router information to local hosts on Cisco router. This includes ability to ...

How to configure IPv6 Static Route - Lessons Discussion

The “ipv6 route 2001::2/128 fastEthernet 0/0 FE80::CE0A:22FF:FED5:0” command uses the link local IP address of the FastEthernet 0/0 interface of ...

Linux IPv6 Static Routes – Ubuntu/Debian & Fedora/RedHat

... configure a default gateway like that: Ubuntu/Debian. iface eth0 inet6 static address xxxx:xxxx::xxxx/64 gateway xxxx:xxxx::yyyy. Fedora ...

1. Create IPv6 Static and Default Route: CORE_RTR fa 1/1 fa1/0 ...

Find an answer to your question 1. Create IPv6 Static and Default Route: CORE_RTR fa 1/1 fa1/0 2001db8: fa0/1 fa0/1 RTR_A RTR_B Lo2 LOO ...

Solved - How to set IPv6 Gateway | The FreeBSD Forums

Hi, on my Linux setup the IPv6 default gateway is set by ip -6 route add default via xx:xx:xx::xx dev ens3 where xx:xx:xx::xx is the IPv6 ...

IPv6 Static Link Local default route configuration - Fedora Forum

The link local address is usually assigned by your DHCP server, which on most home networks ends up being the router. It is used for local ...

Module 15 - Router & Routing Flashcards - Quizlet

Notice that the static default route configuration uses the ___ mask for IPv4 default routes and the ___ prefix for IPv6 default routes. Remember that the IPv4 ...

Using DNSMasq, how do I provide a single static route for an IPv6 ...

Network 1: Internet connected. IPv4 - 192.0.2.0/24 provides a default route via 192.0.2.1; IPv6 - 2001:db8::0/64 provides a default route via ...

IPv6 default route | Ubiquiti Community

Have static IP set on the dual-stack interface to the provider. Next hop interface is set to that IP. We can ping the default gateway of our provider but cannot ...

IPv6 static default route issue in ROS v7.1.1 - MikroTik - Forum

When I try doing the same in v7.1.1 the route stays "filtered", traffic is not forwarded and the route disappears after a few minutes.

IPv6 deployment: Using IPv6 link-local addresses as default gateway

Thus on the network 192.168.0.0/24, the default gateway would usually be 192.168.0.1. In case of network architects using /24 networks for end- ...