Replace your fork seals

Looking for ideas: Stiff suspension after fork seals and oil change

When you fill your forks with oil, you leave an air gap above the oil level. As the fork compresses, the air gap gets smaller. That gap ends up ...

Do you replace fork bushings when doing seals?

Yes, replace the bushings, and don't forget to cut the corner off of a sandwich bag to use to slide the seals onto the fork leg.

How much should it cost to replace Fork Seals on my 2008...

They quoted 3.6 hours (1.8 hours each) for labor at $139 per hour shop rate, plus $70 for the diagnostic, plus parts and shop supplies.

At what Mileage did your fork seals need to be replaced? - VFRworld

You need to be changing your fork oil every 10,000 miles. If you ride a lot change it sooner. So fork seals are cheap so change them once a year ...

How to install new fork seals - RS Warrior Forum

Take your PVC and cuta section out of it so you can snap it onto your chrome fork tube. Once you've mastered that, remove it and grind a relief ...

DIY- Replace fork seals, dust seals and fork oil - ninjette.org

Now remove the dust seal. Gently prying it up and out with a box blade should do the trick. Then use a small flathead to pry off the metal ...

Changing fork seals without stripping forks? | SV Portal Forums

Yes. Pull the bolt out that secures the cartridge to the lower fork leg and the forks will come apart. Put a seal in with a split type fork seal driver.

Fork seals - General Maintenance, Servicing, and Mechanical issues

Changing fork seals on the V1K does require a special tool. I remove the forks from the bike and take them to a local bike shop to have the new ones installed.

Leaking Fork Seals? Fix free - don't replace - V4MuscleBike.com

Make your own free repair tool in minutes and have the repair done in under an hour. This article shows you how.

How to change fork seals video. | Yamaha Super Tenere Forum

Since you have the spring removed anyway, just measure the oil level down from the top of the fork tube before installing the spring. And I found 5w oil is too ...

How to change fork seals video | South Bay Riders

I just watched the video and it shows how to replace the fork seal they neglected to show how to properly replace all the oil in a dual chamber ...

How to: Replace Fork Seals and Change Fork Oil - XJRider.com

10) Use the small flat blade screwdriver and bent nose pliers to remove the fork seal snap ring. 11)Now, using the lower fork leg as a slide ...

Replace Fork Seals Without Disassembling the Forks? - VOG Forum

NO. You can't replace the seals without disassembly (you wouldn't even want to). The seal you see on the outside is a dust seal.

Need to replace fork seals | Steve Saunders Goldwing Forums

I had replaced the fork seals with OEM ones when I had bought the bike two years ago. Then after 2000 miles I had a leak on one of the seals ...

Fork Seal Repair (with limited tools) - YouTube

Spencer learns some tips on changing fork seals in the 2020 Honda CRF with Joe. Thanks for watching, don't forget to share and subscribe.

How To: Change your fork seals (99-02) | R6 Message Net

Make a seal driver. Buy some PVC the same diameter as your forks, cut it in half longways, clamp them together around your forks, and vwalla.

Replacing upside down fork seals at home with no special tools!

:wink: This was more to show people how you can do seals yourself IF needed. I have done a lot of sets like this in the past with ...

FORK SEAL REPLACEMENT | Maintenance and Do-It-Yourself

You do not have to break down the whole Fork to do the fork seals and oil. If you are just doing seals and oil take the fork apart remove all ...

To change or not to change fork oil, that is the question | StromTrooper

Fork oil does need to be changed, there's a lot of wear metals that accumulate in the oil, especially when the bike is new.

Fork seals Replacement | Triumph Rat Motorcycle Forums

You can get seals from a number of different suppliers and it isn't all that difficult a job if you have a few tools.