what level fork oil is the best for stunting

I like to use 15wt synthetic fork oil in most of my bikes when the forks are set-up good. Click to expand... The chart that LDR linked ...

Refilled each fork leg with 150ml of 15w oil (just ended up using my engine oil as it was the right weight) Atomik forks are quite soft from ...

Yes it is. When you are rebuilding your forks, if the book says add 125cc of fork oil, then measure out 125cc and pour it in.

"With the fork supported upright and the tube compressed: The Right fork takes ~ 22.7 oz. Also measure from the top edge down to the fluid level ...

I highly recommend Bel Ray 15W Fork Oil for the KZ650C1. 8. Temporarily replace the top bolt and remove the bottle jack. Pump the forks a few ...

The air at the top of the fork serves as a secondary spring which only has a noticeable effect when the fork is near fully compressed. Smaller ...

I don't have cartridges, but I do have Traxxion AR25 damper rods. I'm using the same oil and weight as you and have it set at 110mm from the top ...

If you are flushing oil only, its $10 for a bottle of quality maxima green label, I suggest 7.5wt or 10wt if you do street and track. You need a ...

^^^ what he said, once you add your 510 mL of the fork oil, you have to set the fork oil height to 100 mm. if you're not confident doing it ...

I just have to set it in a glass of water or something first to find out the measurement of how high the bobber sits on top of the fluid and let ...

Thicker starting fluid might make each click too much of a jump in resistance so that you might get to a position that you cant get the right ...

Actually, 10w works quite well, especially in hot climates. It doesn't make the forks operate slower. What it does do is give your compression ...

Going from 15 to 35 wieght is pretty huge, but if it works it works. Very difficult to find published fork oil quantities on these harley's for ...

What suspension oil is has good lube properties, easily available, and not stratospheric price? Also thinking of going slightly lighter weights ...

"better" in which situations? What problem did you have with the fork? Thanks. Paul S. ---- ...

There is a very small ding in the right side inner fork tube on my '02 R1. . .it is very low so the fork doesn't even compress down that far ...

I never compressed the forks. I put fluid in 5.5 inch from the top with the legs extended! No wonder it is such a rough ride. No where for the ...

Right fork fluid level is 75 mm (+/- 2) from top of outer tube, and takes about 410 mL for a fluid change or 478 mL (+/- 2.5) when dry. Left ...

Hi everyone, It seems the recommended way to do for fork oil is by height from the top when compressed. The manual says the volume is 503ml~ ...

Compress the fork tube fully and measure the fluid level from the top end of the fork tube. ... Extend fork tube and install fork spring with ...