Events2Join

Front bumper side screw in problem


screw for bumper cover ?? | Pontiac Solstice Forum

Here they are side by side. Image. It's trial and error, as one manufacturer will coat them strongly (making them look powder ...

How to Fix Broken Bolt Holes on Top of Front Bumper?

Because these are broken the line between the bumper and the hood when the hood is closed it not aligned correctly (the passenger side of the bumper sits ...

Jetta bumper problems | Volkswagen Jetta Junkies

My Jetta's front bumper is hanging down off its side screws like this. When I talked to the repair guy, he said the fix would cost $400.

Front bumper frame bolt won't thread in - Jeep Forum

If so, it's possible the mounting bolt holes weren't drilled properly and they just need a little reaming. Or does the bolt not thread in ...

Mysterious Screw under Front Bumper - Mercedes-Benz GLA Forum

Or you can use a flathead to unscrew it? This is a 250 with sports package and I was intended to take out the two sides underneath the bumper ...

Front bumper bolts have caps? - Ford Truck Enthusiasts Forums

The bolts have a square underneath the head which locks into the bumper, you need to keep the heads pressed into the bumper. Try tightening the ...

Patching screw holes in front bumper - CrossfireForum

If it won't rub out, you will have to have your bumper repaired and painted. If the center will rub clean, you can find flush plastic plugs to ...

Screws for Front Bumper | Acura MDX SUV Forums

I don't remember these screws in particular from the multiple times I've had my front bumper off. Unless it's a large bolt, it doesn't matter ...

How to tighten front fender to bumper bolts?

My 09' has a small issue where the passenger side fender to bumper is loose. I'm able to peek through and see 2 bolts that I assume hold them together.

Front Bumper re-install, clips under headlight not seating right

They have assorted snaps at home depot/Lowes in the screw/fitting aisle. I always go there for various snaps, plugs, buttons. Exactly like OE ...

Bumper issue | Chevy Silverado and GMC Sierra Forum

Try loosing up that side bracket that has 1 15mm bolt on the bumper, then 2 15mm bolts on the frame. Then using something like a floor jack and a block of wood ...

Broken front bumper clips. - Mustang6G.com

... repair it or screw it and get a Roush front fascia. ... I had the exact same issue of bumper popping out at the passenger side where it meets the ...

Front Bumper mounting problems - Nissan 370Z Forum

I have to stop and put in fresh rivets. I have though about 1/4 inch self tapping screws. Anyone else had any having problems? This dose show ...

So my front bumper fell off today, anyone got any super glue?

if the clip cavities in the bumer are ripped off, it is a problem- invest in some super glue. if the plastic peices that bolt to the subframe ...

2014 - Front bumper detached - repair options?

No matter which way you go it won't be permanent. I would go the 2 sided tape route and apply it just under the broken tab. Another thought is ...

Stripped bolts on front bumper - Jeep Wrangler TJ Forum

Cut the bumper off like suggested, then put a good heavy tack weld on the nuts. Tack the loose ones and also the ones you haven't tried yet to be sure they ...

Front lip problem - BMW M3 and BMW M4 Forum - Bimmerpost

Use nuts and bolts. Drill the bolt through the lip and the bumper (drill a pilot hole first) and use a wrench to hold the nut on the other side as you drill it ...

Sagging Front Bumper (GR/GV) - IW STi Forum

If it is sagging at the sides and the fender brackets are lose, take the screw out of it and tie it down across with electrical wire.

Front bumper removal problem - Camaro5 Chevy Camaro Forum ...

The top bolt on each side just keeps spinning. The bumper is just hanging on by those 2 bolts and I see in the gap of the fender and bumper the ...

Front Bumper won't come off - Pontiac G8 Forum

I know someone else on here had a problem like this where their bolts attached from the bottom rather than the top which is my case as well. I ...