Phantom Power problems ???

Geprc Phantom power problems after crash - IntoFPV Forum

sounds like a fried regulator. Hi WoodenShoeNo, If you have no voltage {I will use 5 volt as example} on the 5v regulator, you can add an ...

Should phantom power be supplied by a linear supply? - GroupDIY

A linear supply will have 120Hz (or 100, depending on where you live) ripple, while a switching supply will have higher frequency noise.

"Weak" phantom power on Tascam DR-100? - Taperssection.com

Has anyone encountered the problem of the DR-100 generating audible hum when two phantom microphones are being used? It is likely to be a ...

Watch out using phantom power - Blackmagic Forum • View topic

You should never connect or disconnect anything to an XLR input while phantom power for that input is enabled. That is true for any camera, ...

PV6 usb. Phantom power. - Peavey Forum

There have been no problems reported with the phantom power supply in PV mixers. Try disconnecting the power supply to the lap top and see if the noise is gone.

Phantom power supply? External mic preamp? Plug-in power?

Phantom power has nothing to do with pre-amp performance, but some mics like the NTG-2 and the MKE600 produce a stronger signal when running ...

Phantom Power - How to Avoid Damaging Your Microphones

Phantom power is used to turn on any condenser microphone such as small pencil condenser mics, and large diaphragm vocal microphones.

Phantom Power 48v Producing Background Noise

1) Your PSU is bad, causing "minor" transients on the 5V power line · 2) Your XLR to USB ADC doesn't filter the 5V properly, so that noise is ...

Phantom Power Current Draw in New Mics - Mandolin Cafe Forum

But any expectation of a higher voltage is simply mistaken. The "voltage dropping" effect of the resistors in a phantom power supply is ...

Audiofuse Studio - 48v phantom power noise - Arturia Forums

Hey all, I just bought an Audiofuse Studio to replace an Apollo Twin, and I'm impressed with it, except for one big problem--activating ...

MOTU Mk3 Ultralite - loud white noise when using phantom power

The two most likely culprits still are a) inadequate power supply b) microphone. The easiest way to check both is to purchase replacements from ...

Focusrite issue (phantom power) - The Gear Page

Do you have a voltmeter? Put it on DC and measure between Pin 1-2, and pin 1-3...you should see 48V. If not, then the problem is inside the ...

48v phantom power question - The Unofficial Martin Guitar Forum

It's not unusual for amps to have under-powered phantom power. It's also, in my estimation, unforgivable. I would never buy an amp that ...

Phantom power question - Gearspace

Tube condenser and dynamic mics are in no way affected or harmed by phantom power being sent to them.

Phantom power problems with the Babyface pro FS. - RME Forum

Re: Phantom power problems with the Babyface pro FS. I had the same problem (with a Thomann FetAmp but I'd guess they are essentially the same).

UR 22 mkII phantom power problem - Steinberg Forums

I just bought steinberg UR 22 mk II. And i'm having trouble when recording with +48v phantom power on + condenser mic.

Mic. phantom power resistor values. - EEVblog

So the principal requirement for resistors in series with a phantom power supply is to limit the DC current through the transformer windings.

Para-Acoustic DI XLR/Phantom Power problems - LR Baggs forum

The XLR output doesn't work when phantom power is coming in from the board, even if I take the battery out completely. Still works fine on 9v battery power.

Noise and Grounding: what's the point of external phantom power ...

I have a AT2035 condenser mic attached to it, using the onboard phantom power capabilities. The interface occasionally malfunctions and makes ...

Have a 24c and want to use phantom power on only one of the ...

So I have a guitar amp with an XLR output for recording, I also have a Dynamic mic for instrument ... input with phantom power on and one ...