I think I spun a bearing
Question on spun rod bearing....... - DSMTalk Forums
An actual Spun bearing is when the bearing gets damaged enough to SPIN around in the journal it's trying to protect. Nick Do you know what " ...
Spun main | Lexus-Toyota V8 UZFE Forums - Lextreme
My always hopeful guess this time is that when the 4th bearing spun this created a oil pressure leak and allowed the other main bearings to ...
Spun Bearing: What's that? - The Show - Car Talk Community
What it means is that the bearing surface was starved of oil, and the inner face ground into the “race” (not sure if correct term here–I mean ...
Is this a "spun rod bearing"? C/PIC - Yamaha R1 Forum
Nah, that bit of rotation is normal, a spun bearing would be all scored up and look kind of burned. ... I think someone installed the bearings ...
SPUN BEARING? NEED INFO | DuramaxDiesels.com
No vibrations. I can't think of anything that can make that noise except main or rod bearings. Anyone ever experienced this?
Spun Rod Bearings - Honda-Acura.net
If it has spun before, it will spin again. You need to replace everything that has a scored surface including the crank and affected rods.
Spun PTO crank bearing - Hardcore Sledder
Do you think the abuse of an impact could cause the bearing to spin though, that's what I'm really wondering. :dunno: I'll look at the ...
Spun bearing - Yesterday's Tractors
The only way I know that you can tell a spun rod or main bearing from any other main or rod bearing failure is to take it apart and look. [Log ...
I spun a bearing, didn't I - RX7Club.com
I personally think you spun the bearing. Who built your motor and when was it built? If it did spin, you may need new Iron's and e-shaft.
Really depressed. Spun rod bearing. - Mustang Bullitt Forum
How much is each? Image. Current mods:.
Possible spun bearing [Archive] - 3000GT / Stealth / GTO Forum
Sounds like you spun a bearing. You wont be able to tell until you take it apart for sure. If they did spin you will need to get everything ...
dreaded(to most) spun a rod bearing...dang - GMTNation
Spun bearings damage the block itself and becomes unusable. It can't even be rebuilt. I spun a bearing in my '93 S10 Blazer 4.3. When I got a ...
Best course of Action after a spun bearing. - K20A.org
It really depends on how bad the scratches/socres are. The safe thing to do would be get a new crank and rod and use the #s to buy the right bearings.
spun bearing?? | Busa problems | Hayabusa Owners Group
On spun bearings, you have to turn them down, build hem back up and then turn it back down to factory specs. They don't make bigger bearings.
R50/R53 Help Diagnose Between Spun Bearing and Bad S/C
Spun engine bearings are very rhythmic and accelerate with engine rpm. Also with 40 miles of driving on a spun engine bearing the knocking would ...
Spun Rod Bearing, Something Important You Should Know
I think it's like being a singer. You have to have a good voice, but perhaps that voice can be transformed into a great voice. In motor racing, ...
Spun or worn rod bearing test - Orange Tractor Talks
A “failed” bearing will display loss of material, smearing of babbit coatings, increased operating temperatures (darkened/overheated), or corrosion, etc. This ...
Spun Bearing? Noooooo!!!!! - Third Generation F-Body Message ...
If it is a spun bearing, you will have to pull the motor out to replace it and fix whatever damage it has done. You might as well go through the ...
major catastrophe!! spun bearing, probably. help! : MGB & GT Forum
spun bearing, probably. help! 14 years ago by balloonfoot. Novato, CA, USA USA. Top Contributor. you got that right I think.....spun bearing and seized when hot ...
Spun bearing at 60k miles - Acura TLX Forum
The manager said this is only the 2nd spun bearing he's seen in a honda 3.5. His guess is that it may have been an imperfection in the bearing ...