Events2Join

Power Windows/Locks


all windows and door locks quit working : 2000-2005 (other than GXP)

The rear and passenger doors communicate through the Driver Door Module (DDM) for things such as power window function, lock status etc.

Power windows, door lock don't work, which fuse? - MDXers.org

He said, trust me, it is a fuse. Go back, pull and visually check each one. Sure enough, a 7.5 amp fuse was blown. It was number 21 in the ...

All Power Windows and Power Locks Do Not Work - 4Runner Forum

Couldn't find the bad ground wire in the door - such a small area. The power source to the switch is the blue wire with a red stripe (at one of ...

Power windows locks oem conversion - DodgeForum.com

2nd Gen Ram Tech - Power windows locks oem conversion - I want to add power windows, locks, mirrors, and remote keyless entry to my 99 dodge ...

2003 E350 swap power windows and locks | Expedition Portal

Unless mine is different they are a direct plug in, manual window doors will accept all the hardware. Ground out 2 wires in the passenger ...

2014 - All of a sudden, Power Window and Lock Problem? - SOLVED!

All of a sudden, driver's side door panel stopped working. The lock and all four window switches. It just got dark out, and when looking at ...

Part I: Adding Power Windows and Door Locks

I've seen several people install power locks and windows before. It certainly updates the TJ in terms of making it more modern, that's for sure.

Power windows, locks, conversion - Pontiac GTO Forum

I installed a power window conversion kit from New Relics on my 72. This was NOT a very difficult install at all. It did take the better part of a day and ...

is this possible? (convert manual to power windows/locks)

I just bought a kit on ebay to convert locks and windows to automatic, since i was in the same predicament as you. installation includes taking off door panels.

Power Windows, Locks, Dash light failure. - NASIOC

Power windows made odd clicking sounds like relay noise underneath dash or in door card while going up, or down. During this noise the dash lights would ...

converting to power windows and locks - DODGE RAM FORUM

As long as you have the proper wiring harnesses, and those are pretty basic features so you should, then you should be able to hook up, and then ...

Power windows/lock/mirror issues. - Honda Forum Discussion

Very common issue on EKs. Likely some broken wires in the driver's door jam to body harness. You can try opening the door with the key ON.

Power Windows and Locks dont work - Honda Accord Forum

General Tech Help - Power Windows and Locks dont work - I have a 2004 Honda Accord LX 2.4 and found a penny in the cigarette socket causing ...

Power Window Lock Button (strange behavior) - Honda Pilot Forums

It is correct, only the drivers window can be operated when the LOCK button is activated and lite up. When the power window lock button is ...

How To: 92-95 Civic Coupe/Hatch Power Windows, Locks, and ...

It's located above the dash fusebox and is super easy to spot as it's the blue 12 pin connector. Every Civic has this one since it's also used ...

adding power windows and locks to my 95 obs xl

From the donor truck, get the harness that runs just below the windshield and plugs into the door harness on each side. There will be two wires ...

Help! - Power Windows, Locks, Hatch, Fuel Latch Not Working

Start by checking fuse #14. If it's ok, then you likely have an issue with the CCM or the factory made splices in it's wiring harness. Have a ...

Power seat/windows/locks not working. - IH8MUD Forum

After searching through the archives, I found that the ECU-B2 powers the seat, window and moonroof. The fuse is like blown or damaged.

Power windows and door locks? Switch locations? | Bronco6G

Yes, the switches for the power locks are in the doors. The switches for the windows are in the center console - and the rear of the center ...

Drivers side window,power door locks wont work - iFixit

The most likely cause of your problem is the master switch in the drivers door. The windows and the locks are on two separate circuits.