Replaced valve cover gaskets
Valve Cover Replacement - Nissan XTerra Forum
Yep. It's not too difficult, but do take your time the first time around. Make sure you have the following replacement gaskets.
Acura TSX: How to Replace Valve Cover Gasket - AcuraZine
This how-to will guide you through the process and will show you how to change these out without breaking a sweat.
valve cover gasket replacement - Tahoe Yukon Forum
The gasket sits in a groove around the base of the cover, easy to remove and replace. Since it's rubber, it does not require any sealant.
LR4 Valve Cover Gasket Replacement?
Looks like fuel rail, depressurization of fuel system, injectors, then valve cover removal and gasket replacement, rtv sealant, etc.
Valve cover leaks after replacing gasket. Why? - Bimmerforums.com
I recommend buying a new gasket as nothing can replace a gasket completely. Then add the gasket sealer. I did it and have not had a single problem.
Valve Cover Gasket Replacement - Maserati Forum
Replaced both valve Cover gaskets on weekend together with the 8 spark plug gaskets. Lots of stuff to remove to get access, but pretty straight forward.
You reach underneath and painfully remove the 10 bolts on the intake manifold. It all comes off as one piece.
N55 valve cover gasket replacement cost - Bimmerpost
My shop quoted $1000 to replace, and warned if the valve cover is warped, a new one is $600 additional. I'll do spark plugs at the same time ($385), and save ...
Replaced Valve Cover/gaskets now have rough idle - Bimmerfest
I recently replaced my valve cover/gaskets on my 2007 BMW X3 N52 E83 and I am now experiencing a rough idle, would a pinched gasket cause this?
How to Replace Valve Cover Gaskets - MotorTrend
You're under the hood doing some routine maintenance when you discover the engine is leaking oil. Don't panic.
Wrangler JK won't start after valve cover gasket replacement.
2015 RHD Wrangler JK 3.6 Pentastar won't start. Engine cranks over fine. I went back and made sure all plugs were securely plugged in.
Replaced Valve Cover Gaskets - Nissan Frontier Forum
1. Cut the 2 Coolant Hoses - Those 2 Coolant Hoses on the back are BAKED ON. Take a razor and cut them off. This will save you hours. Make sure you have new ...
How concerned should I be about this valve cover gasket leak?
One can get the new valve covers with all the associated hardware to just replacing the gasket and spark plug tubes. The car has never left a drop of oil on the ...
5.7L Valve Cover Gasket Change Process w - Toyota Tundra Forum
I've seen some questions on the Valve Cover gasket seal change on the 5.7L engine. I took some photos along the way and want to help others through the process.
Valve cover gaskets replacement kit - Toyota 4Runner Forum
I normally use the Fel-Pro valve gaskets and went with the OEM brand. Now they leak. Back to Fel-Pro for me. Their gaskets are a bit softer than the OEM ...
Replace valve cover gasket - ClubLexus - Lexus Forum Discussion
From what I remember, you will have to remove the spark plug/tubes, move some evap system lines, disconnect the intake and a few other things ...
Replacement of Worn out Valve Cover Gasket - Kia Forum
You need to use a small screwdriver and remove all silicon from the bolt holes. It's spongy and bolts have a tendency to break. Use a power wire ...
any tips? replacing valve cover gaskets on 455
I use the rubber gaskets, RTV on the valve cover side and not on the head. If you ever need to remove the valve cover you don't need to replace the gasket.
3.5L Valve Cover Gasket Project - Nissan Forum
Otherwise, replacing the entire plastic valve cover with integrated seals is your best option. Not the only option however. With a hole saw and ...
Valve cover gasket replacement | Acura MDX SUV Forums
The replacement of the front valve cover gasket wasn't too bad, took about 45 minutes. The replacement of the rear was a freaking nightmare! So ...