rattling noise when car put into gear... HELP!

Wierd rattling noise when I shift into 2nd gear - Honda Accord Forum

Check exhaust heatshields or just the exhaust flexing & touching the floorpan. It might be this, & it's easy to check to rule out.

Gear Rattle / Chatter Sound When Car Is Idle, in Neutral, and the ...

Equally, just a gentle touch on the accelerator pedal seems to stop the noise - even while the car is in neutral and without the clutch being ...

WHY CLUNKING NOISE SOUND WHEN SHIFTING GEARS, SHIFT ...

WHY CLUNKING NOISE SOUND WHEN SHIFTING GEARS, SHIFT FROM PARK TO REVERSE DRIVE If you hear clunking noise when shifting gears on your car in ...

rattling noise, only when in gear. Not there in park or neutral.

I am hearing this rattling noise (sounds like a pully but it isn't) only when in gear at idle or low speeds (I can't tell if it is making noise at high speeds, ...

New Sound/Rattle only in "D" or "R" at idle- Can you identify it?

Check the exhaust heat shields, they can sometimes get loose and rattle. When in gear and not moving there's a bit more vibration in the ...

Help with weird rattle from 2002 Rav4 when cold and put into gear

It's had a bizarre noise that has gotten progressively worse. Only happens at first start of each morning, and only when put into gear.

Rattling Noise - Sounds like its coming from the front of the engine?

Some people use mobile1. I was having a similar issue when I started the car while idling I would get and rattiling noise that would go away ...

Clutch Rattling Noise? - ZPOST - Bimmerpost

When the load is off (clutch out) the bearing is just lightly in contact with the pressure plate so it's spinning a bit and rattling as much as the worn ...

Rattle sound when slowing down out of gear or at really ... - AudiWorld

Nor does it happen when the vehicle is stationary, out of gear, and you rev the engine. It really sounds like a ball bearing has come out in one ...

Ticking/clicking noise - gears? 2015 Grand Cherokee [SOLVED]

put them back. Got back in the car... 4wd-low engaged without a problem. Put it back into normal driving mode, ticking stopped. Took ...

Need help chasing down a noise! - NASIOC

Happens when shifting from 1-2. Does not happen when car is out of gear. Only when rolling in gear and putting the clutch pedal to the floor ...

Strange sound when reaching biting point in 1st gear only

So put the two things together and I came to the conclusion that uneven wear and moisture trapped in the uneven wear was causing the noise. The ...

Strange noise when in R/D, but not in Neutral or Park

It's a belt or pulley issue. When the car is in gear there is a slight load on the drive train. That will change the harmonics of the entire car ...

Rattling noise while at idle and in gear only | Lightning Rodder

The slight wobble is not an issue according to responses I got when questioning about it. So eye our lower while running. Carefully put a finger ...

Please Help!!rattling Noise On 1st. Gear - CorvetteForum

This is very common with all MN6s. More gas will help, but it is something we all live with. As far as the noise when you turn your car off if ...

"Rattling" sound from auto trans when idling in gear

Now that rattle is probably the torque converter. Very common on the early Gen 3's. I have it, too, on my '03. I just live with it. Search this ...

Rattle in neutral | The M3cutters

If it rattles with the clutch is pressed it's the release bearing, if it rattles when the clutch isn't pressed then it's probably a gearbox bearing or ...

Rattling Noise Only When In Reverse Or Drive. - Ford Taurus Forum

There is a heat shield attached to the car's floorboards over the rear most catalytic converter. This shield is known to come loose and tap on ...

Rattle noise only in fifth Gear - YotaTech Forums

driveshaft vibration can be felt through the shifter handle. can you get under vehicle, trans in neutral, and try shaking/turning the driveshaft ...

Rattle While Idling in Gear - Page 2 - Community of Ford Truck Fans

A small loose heat shield hidden behind the front skid plate. Little WD-40 and a ratchet, and she sounds good as new again.