what's gonna happen if I use a balanced cable

Why are speaker cables TS thus unbalanced - Logic Pro Help

3) You are confusing the cable with the connector. Balanced connection needs to carry one "hot" signal and one "cold" and then there's ground.

Balanced vs unbalanced | Audio Science Review (ASR) Forum

However unbalanced single ended has a fundamental flaw. The low signal wire (shield) can also connect one component chassis to another and can ...

RCA vs Balanced | pink fish media

Balanced cables provide better rejection of RFI, so yes they are better for long runs. For short runs, it's unlikely that you'll get enough RFI to have an ...

Is Balanced Better? Pros & Cons of Balanced vs. Single-Ended

In other words, if an amp is designed to be balanced and has a balanced headphone output, that balanced output should be used and will have the ...

Efficacy of Balanced XLR Cables for Noise Reduction

The capacitance of the cable will also affect the signal. Higher capacitance will attenuate high frequencies more. The better cables use thicker ...

Balanced, unbalanced, stereo, mono, noise & patch bays. - MOD ...

It's when the cable is carrying identical signals on its two halves that noise cancelling can happen, and so balanced for stereo is as much use as unbalanced ...

Balanced to rca - General DAC/Amp/DAP Discussion

As balanced audio does not share a common ground, there is a chance you may kill your DAC with such a cable. 6 Likes. generic June 22, 2020, 6: ...

Balanced Instrument Cable on Active Bass ? - Sweetwater

Your bass has an unbalanced output; your bass amp (or DI) has an unbalanced input. There's no point in using balanced cables to connect those. Wrong tool for ...

What balanced to unbalanced cables do you use for guitar rack rigs?

Vice versa, if a source provides unbalanced signal and the destination accepts balanced, connecting the destination with a XLR doesn't make the ...

Balanced / Unbalanced? - The Keyboard Corner

Balanced cables only help if your instrument can supply a balanced output and your amp/recorder can accept a balanced input.

What happens in terms of wiring when you use a TRS adaptor with ...

I am assuming that the RCA cable's signal is doubled and put into both the tip and the ring. The mixer is treating Tip and Ring as a balanced ...

What is the difference between a balanced cable and an ...

This is the ingenuity of balanced cables: the two signals will each capture parasitic noise in their path. When the polarity of the cold signal ...

Does connecting a balanced cable to a non balanced one (say 2.5 ...

Where you run into trouble with balanced/non-balanced adapters is if you connect a single-ended headphone through an adapter to a balanced amp.

Can I use balanced cables to feed FX return (unbalanced) ins

The thing is it outputs balanced signal (on XLR connectors). May I use XLR-to-TRS balanced cable to feed the unbalanced FX return inputs on the ...

Unbalanced or Balanced - Elektron Gear - Elektronauts

I stick with unbalanced cables when I can with my elektron gear. Whenever I use balanced cables, I tend to run into issues (phase cancellation, signal loss) ...

Balanced and unbalanced output, use simultaneously - DACs

Using a splitter with two different cables will “mix” part of the sounds of the cables. But with cables that are fairly neutral this shouldn't ...

Balanced and twisted RCA? | DIYMobileAudio.com Car Stereo Forum

The twisted pairs are not good for unbalanced equipment, which, from what I understand, is most equipment used in car audio. This is because ...

Why are balanced audio cables better? - Steve Hoffman Music Forums

In a single ended configuration current runs through they shield. That means that all shields can have slightly different potentials. If shields ...

Hum with balanced cables - Polk Audio Forum

By Design Balanced cables have the lowest noise floor compared to unbalanced. It is not physically possible for a un balanced cable to have a ...

Balanced Cables VS Unbalanced Audio Cables - From Zero To Studio

So unbalanced cables consist of two wires: a signal wire, and a ground wire. And a good example of an unbalanced cable is just gonna be your ...