[SOLVED] Routing traffic via ppp0

According to your output only one IP ("32.32.11.1/255.255.255.255") gets ppp0. So, if you want to allow more then one address, you need to ...

host1 has internet connection through interface eth0 ; · host1 dial up host2 and establishes a PPP connection with it; · host2 has no internet ...

Using New Routing Tables ... Now we've directed traffic to that routing table 168 , but it would be empty, only need to add a default route to it ...

Heres scenario: I got linux server which connects to the internet via pppoe-start, meaning that router is in bridge mode. All other machines ...

Ideal solution would be to always route all FTP via eth0 if that is easy, if not then what should I add to my bash script to route the traffic ...

Theres gotta be a way to route all traffic through the VPN route ppp0 . I tried adding persist and maxfail 0 to the pptp config file but it did ...

Looking at the routing table I see that something adds a ppp0 route to the IP of the gateway I am connecting to. That breaks the communication ...

Ideally I'd like to ensure that all traffic is routed via the ppp0 interface, except for the LAN network which should go to eth0. I've tried ...

I see your default route is pointing to eth0, you will need to point your default route to ppp0 instead. Remove the default route and try ...

11.2 arrives at gi0/0, the router will sent the answer traffic out via the ppp interface (according to his routing table) and you have ...

as discussed in pull request #90 which implemented that a new ppp device is used when ppp0 is already there, I have noticed a problem when ...

would possibly help you. This enables to route all traffic from eth0 via ppp0 to the Internet. Is that what you want? However, this already ...

In my case, eth1 is the device I want to be an available gateway on my LAN, and ppp0 is the name of my VPN connection when it's active on ...

0.0 whenever the Ethernet connection is active. One way to solve this issue is by adjusting the routing table to use different gateways for ...

route traffic to specific pppoe-client and don't hop to the next route [SOLVED] ... routing the traffic through the default route which i don't ...

Below are the steps I have to take after login to ensure that the interfaces are up properly and the routing as per the localroutes file are ...

... route gets set that (seems to me) routes all traffic through ppp0. This means I have no local access. Here's my routing table: [tom@archie ...

If the line is present check to see what device it specifies. If it specifies 'ppp0' then your routing setup is fine. If it specifies a ...

... ppp0 to be default route ... solved by adding local ip = 172.16.57.3 to xl2tpd.conf under [lac servername] and routing traffic through that.

in the face of changing network topology is effectively solved through the use of interior gateway routing protocols but the consumer-grade services