Active/Passive HA cluster nodes
Active-Active vs. Active-Passive High-Availability Clustering | JSCAPE
Active-active high availability clusters distribute workloads evenly across all nodes, ensuring optimal load balancing. In contrast, an active-passive setup ...
About Active/Passive Clustering - Software AG Documentation
Active/passive clustering is a concept that uses clustering software and special purpose hardware to minimize system downtime. Active/passive clusters are ...
High Availability Cluster: Concepts and Architecture - NetApp BlueXP
Active/Passive Cluster. A failover ensures that when a node loss occurs within a service group, it is quickly offset by other nodes in that ...
Active-active—All nodes receive traffic. Active-active deployments support load balancing and failover among up to eight cluster members. In an active-passive ...
HA Clustering Overview - Palo Alto Networks
In an HA cluster, all members are considered active; there is no concept of passive firewalls except for HA pairs, which can keep their active/passive ...
High-availability cluster - Wikipedia
Active/active — Traffic intended for the failed node is either passed onto an existing node or load balanced across the remaining nodes. · Active/passive — ...
Chapter 5. Configuring an active/passive Apache HTTP server in a ...
Configure an active/passive Apache HTTP server in a two-node Red Hat Enterprise Linux High Availability Add-On cluster with the following procedure.
High Availability (HA) Firewall - Check Point Software Technologies
In the Active/Active mode multiple firewalls actively share the load across the cluster, while in the Active/Passive mode one firewall is a standby that becomes ...
Deploying an active-passive cluster
In an active-passive cluster, one node is the active appliance; it processes traffic. The other node is passive; it is ready to assume the role of the active ...
About Active/Passive Clustering - Software AG Documentation
In a high availability active/passive clustered environment, one of the nodes in the cluster will be active and the other nodes will be inactive. When the ...
Deploying an Active/Passive Cluster - Ivanti
An active/passive cluster configuration provides high availability. Active/passive configurations allows seamless failover without the need to set up any ...
What is a Two Node Cluster Architecture? - High Availability
An Active/Passive configuration refers to one of the cluster nodes always being active and the other passive; in other words, only one node is the master ...
Configure active-passive HA - Sophos Firewall
On the primary device, go to System services > High availability. · Set Initial device role to Primary (active-passive). · Under HA configuration ...
Introduction to High-Availability Clusters On Linux And Other Systems
Active-Passive Cluster - A cluster where only one node runs a given service at a time, and the other nodes are in stand-by to take over, should the need arise.
Configuring Active-Active High Availability and Additional Passive ...
Adding a third node configured to take over in the event that both other nodes are down, provides further redundancy while keeping the ...
Decoding High-availability Configurations for Massive Data Networks
Active-passive represents a configuration where one node serves as the active instance, handling all incoming requests, while others remain ...
Chapter 1. High Availability Add-On overview
Node failures in a high availability cluster are not visible from clients outside the cluster. (High availability clusters are sometimes referred to as failover ...
Active/Passive Chassis Cluster Deployments | Junos OS
In cluster mode, the configuration is synchronized over the control link between the nodes when you execute a commit command. All commands are applied to both ...
Set up High Availability in Hot-Standby (Active-Passive) or Cluster ...
In this mode, there is a primary node that is handling all of the traffic. The other node is ready and waiting to take over should the primary fail. This mode ...
4.3.2. Active-Passive HA Cluster - UserGate Support & Service |
In the Active-Passive mode, one of the servers operates as the master node that processes traffic and the rest act as backup. On each of the cluster nodes, ...