Brass Nut installing?

Brass, phosphor bronze (or any cupro-nickel alloy) are self-lubricating metals and for that reason the most difficult to glue. Again CA is the ...

There is a little drawback though. You need to drill four small holes into the neck, under the nut. The screws for the D and G string are right ...

I think I murdered my nut slotting files with this one. Cutting a brass nut from scratch is time consuiming but worth it in the end.

Strat-Talker ... Worked on fitting the brass nut last night and I'm happy to say everything went really smooth. Being brass, I had to use a ...

This video is about How to Install a Brass Nut on a Les Paul Studio Brass nut: ...

In This Video I go over the simple way to install and swap guitar nuts for the head stock.

Can someone educate me on the removal of a factory nut and the installation of a brass one? Thanks, Keith.

I fitted one a while back, but to be honest any gain in resonance or sustain will only affect the open strings. Once you fret a string, the ...

Roughen the underside of nut with coarse file or similar. I have used basses with the nut just held in by string tension and no problems - ...

howto #diy #brassnut #bonenut #remove #install #guitar #fender #squier #telecaster #stratocaster.

Very cool I bought one of these in chrome but haven't got a time to install it yet, did you file the slots on the low E and A string to fit the ...

Let's install a Brass Nut and see if it fixes our tuning issues with the Kramer Baretta Special! Buy the Kaynes 43mm Brass Nut here: ...

Then I loaded the bass into our PLEK machine, and programmed it to cut a new nut slot from the block I had just installed. To return the ...

In this short video I replace a Graph Tech nut with a brass nut. I recorded some guitar playing examples on each, and then edited them ...

If when installing the top of the Loopcase, you push down on the screw without turning it, it is possible to push out the brass nut.

Well Nuts, also called rubber nuts or rawlnuts, are removable rivet nuts comprised of an EPDM Neoprene nut and a brass insert nut.

Hi I've been interested in installing a brass nut on my Stratocaster. Has anybody tried this? What difference does it make?

I am thinking of installing a brass nut on my vip and on a hardtail strat project. I have a brass nut on an old 76 Ibanez LP and I really ...

I've had guitars with brass nuts installed ( not by me) in the ... My custom brass nut, EVO frets I installed, and Optima gold strings.

I have had a brass nut on my '68 Strat since around 1979; it was built and installed by Ralph Novak... some people here may be familiar with his ...