Events2Join

Cold Start Loud Ticking Noise v6 2013


Cold Start Loud Ticking Noise v6 2013 | Drive Accord Honda Forums

I would agree that it is the timing belt tensioner I had the same issue on my 2013 accord around 90k miles. Sounded like a diesel on cold start ...

3.6 engine ticking noise when cold - Charger Forums

The factory oil did make that noise when cold before I changed out the oil. This is the 3.6L version of the "Hemi Tick"! I found that the cam ...

v6 engine tick - cold start - Ford Mustang Forums

2010-2014 Mustang - v6 engine tick - cold start - I have read on a bunch of other mustang forums that people are experiencing a very loud ...

2013 Camaro V-6 Engine Ticking Noise? - Camaro5.com

The rapid ticking noise on cold start up is the fuel pump (located on the rear of the left cylinder head) building up high fuel pressure. When ...

Engine Ticking on Startup, Problem NOT Solved.

I bought my 2013 JK new 5 years ago. Almost from the beginning, on any cold start, there was a ticking sound coming from the engine. It only ...

I have a ticking "lifter" on cold startup. do you? - MustangForums.com

Some 2011 mustang 3.7L vehicles with an engine build date of June 10th, 2010 or earlier may have an intermittent tick noise from the left hand ...

4th Gen 2009-2014 TL ticking/slapping sound on cold start fix.

This is a common issue. Timing belt tensioner gets so worn out to a point that it makes a slapping/ticking sound on cold starts,then goes ...

Ticking on cold start, Tacoma tick, or something else? - Tacoma World

On my 2013 4.0 V6, I notice a tick on the top end of the engine during a cold start. It's a light tick, doesn't appear to be knocking. it ...

Ticking noise on cold start - MBWorld.org Forums

It sounds like a valve/rocker issue. Assuming you have a V-6 try and determine which side of the engine you hear it from. I am also assuming it ...

2013 Sorento Cold Start valve train noise - Kia Forum

Until the oil can get between the contact surfaces, and the metal can heat up and expand, there is valvetrain noise. My Lambda engines have 247k ...

Cold start ticking noise on cold start lasting around 10-15 seconds ...

Engines are noisier when it is cold as it takes a few seconds to push the more viscous oil around. Because of that you can get ticking ...

Cold start tick, normal or not? - CAMARO6

Presumably, Gen6 engines continue to be built with good lifters. Your symptom sounds like something else. In general, hydraulic lifter engines ...

Brief ticking noise on cold start 3.6L - Jeep Wrangler Forum

... ticking noise from the engine right after start-up. ... V6. The block heater , while a ... 2013 JKR cold start noise. OK, I will start ...

Tapping/ticking when starting my truck in the cold.

its goes away for me once the engine is warmed up. it only makes the sounds when its cold out. in my opinion it almost similar to the ticking ...

3.6 pentastar engine noise- cold start | Allpar Forums

I'd say so. I've been following the Wrangler forums for issues with the motor, and there have been a fair amount of complains about ticking ...

Cold Start Ticking/Tapping/Knocking Noise - Honda Pilot Forums

If you experience a fast-tapping noise at cold start up that fades as the vehicle warms up it is likely that the timing belt tensioner is going ...

Tapping Noise on Cold Start | Hyundai Forums

Woah, that sounds like a real problem. Last time I heard that sound was in my old Toyota V6 pickup that died at at around 240k miles. I would ...

Cold engine clicking/ticking sound - Dodge Avenger Forum

That said, do you have the V6? They have a service bulletin out that has to do with head replacement because certain valves MAY fail prematurely ...

Start Up ticking noise - Community of Ford Truck Fans

Usually cold start ticking is lifters being collapsed until they fill with oil. Or, I've also heard a clacking noise from the timing chain ...

Cold start up ticking noise VVT-i??? - Toyota Nation Forum

ANY time I had a ticking noise on my engines (twice) during initial engine startup it was always a lifter that bled down. It would pump itself ...