Events2Join

DRivers side sits lower than passenger...WHY?


DRivers side sits lower than passenger...WHY? - Honda-Tech

Its because it sags on that side. it does this for two reasons. 1: the motor weight is on that side and the transmission does not weigh enough to balance it ...

Driver side one inch lower than passenger. Why?

The driver side is typically lower than the passenger side due to stock suspension setup and the fact that the fuel tank is on the driver side.

Is the drivers side supposed to sit lower than the passenger side?

That may over stress the passenger side springs enough to counter balance the damage from a fat previous owner driving your car. You may have to ...

Help ,FRONT drivers side lower than passenger by a inch, NOT ...

The reason is because you (the driver) are always in the car and not always a passenger. The bushings and the spring perch (the rubber cupler) ...

why is my truck lower on the driver side than the passenger?

May have took such a jolt that your springs may have compressed a bit far and took away some of their "springiness" for lack of better terms. If ...

passenger side of car 1" lower than drivers side...? - LS1Tech.com

being that the stock springs have that many miles on them, it is possible that the passenger's side has worn out and settled more than the ...

Driver side is lower than passenger | 8th Generation Honda Civic ...

It's because you're always in the driver seat. More weight will make the springs settle a little lower than the other side with no weight.

Need Help. Suspension issue. Car sits lower on Drivers side

Not starting anything bud valid point. Lowering car allows for lower center of gravity. Alignment to lowered ride height takes care of driving ...

Driver side is lower than passenger side in the front

Check your lower control arm bushing. If it's worn out. That can cause the truck also to sag on one side. Take a tape measure & measure from the ...

Driver side sits lower than passenger side…blown shock absorber?

It sounds like the lower ride height on the driver's side could be more related to your suspension springs rather than the shock absorber.

The Rear Driver-side sits Lower than the Rear Passenger-side

If you have adjustable coilovers, the plate may not be set at the same height as the other. Could be premature shock/spring failure. Who knows, ...

Driver's Side Lower Than Passenger's

I don't have exact measurements, but in our garage, which is level, the driver's side was consistently lower than the passenger's side by as ...

Front driver side lower than passenger side - SwedeSpeed

If you're judging by the tire inflation it could be just because the transmission is on the driver's side of the vehicle, either that or the ...

driver side sits lower than passenger after lift - Toyota 4Runner Forum

The driver side is often lower due to the location of the gas tank, among other things (weight of driver stresses springs more causing sag).

Truck sits lower on drivers side than passenger side....???

So I bought and replaced all cab mounts (4 on the cab and 2 core support) with Prothane poly mounts. Truck still sits higher on passenger side ...

Drivers side lower than passenger side | GMC Truck Forum

My drivers side sits lower than the passenger side. Does this have anything to do with tire alignment? And if i crank the keys, would i need to get it ...

Clunking Noise and driver side sits lower than passenger

The clunking noise might be the strut or control arm or strut mount....to check that....id suggest jacking up the side thats making noise on the ...

Driver's side rear much lower than passenger - Pontiac G8 Forum

1 inch ) then something isn't quite right. it is possible when putting on your control arms - you bound up the bushes such that one side doesn't ...

driver side lower than passenger side - ScionLife.com

Its probably because you sit in the drivers side putting more weight on the left springs/struts. My TRD's settled the same way but I put some ...

Lowered my car and not Driver side sits lower than passenger side?

I went out an measured it again and its less than a quarter of an inch. i think im going to wait a week or two for the springs to settle in. the ...