Does anyone know the rotor bolt thread size for rotor removal?

Just did this over the weekend. The thread size is M8 x 1.25 (1.25 is standard pitch for M8, so you should be able to find them at Lowe's, etc.) ...

The bolt size is a 4lb hammer and some percussive maintenance. ... Geeves77, WrecklessAbandon and Bagman like this. Oct 11, 2022 at 11:20 AM. #3.

It is an M8 x 1.25 as JMAZ and CX-5DRIVER commented. No need to drag your rotors into Home Depot.

Everyone knows that rotors are sometimes hard to remove if they are rusted onto the hub. So there are two threaded holes, and you can grab ...

I've read and seen on YouTube videos that on the hat of the rear rotors there's a pair of threaded holes to help, with the aid of 8mm bolts, ...

To remove the front Toyota Venza rotor, there are two drilled threaded bolt holes for pushing against the hub. Does anyone know the thread ...

M8 x 1.25 is also my recollection. Typically I just use a wire brush and a rubber mallet to tap the rotor if needed. Keep rotating the rotor ...

Posting this in case someone is looking for the same info in the future. Just changed the rotors. The 2 bolts are in fact M8x1.25. I bought ...

The bolt thread is a metric 8x1.25.

Of course it would be better to get your hands on some M8 x 1.25 Grade 10.9 bolts and use those. However, if you don't realize that there are ...

So I went to the hardware store to get a bolt of the same size and thread pitch, but with a hex head so I could use a ratchet on it. For info, ...

Normally I use the trick of installing bolts in the 2 tapped rotor holes to pop the rotor loose from the hub. Anyone know the size bolts I need ...

If there is it's probably m8 x 1.25. If you're having trouble, some heat or some love taps (careful to not hit the wheel studs) with a hammer ...

You may be thinking about threading a bolt into the rotor to help remove it. Some rotors have 2 threaded holes on them near the center. If I ...

1" thread length should do. My experience: the holes were very rusted, making me wonder if I had the right thread. I found just screwing them in ...

. Length is not super important, but it ... rotor come off straight. Bolts with the same pitch are used throughout the car ... HOW to CHECK CAR ...

Hi guys, Anyone know the size of the bolts that are used to release the brake rotors? They're not M8. Of all the extra hardware that I have ...

... is a tad longer (I opened the bleeder valve to retract the calipers). Question is: anyone knows what is the size of the holes where you can ...

Anyone know what size bolt I need to buy to help remove the brake rotors? I read there is a tapped hole in them to aid removal but nothing ...

There should be two threaded holes on the rotor if you look carefully. I think a 12mm bolt fits there. Put two bolts and turn them slowly. It'll ...