Effect of heat treatment on the microstructure and ablation ...

Low-temperature reactive melt infiltration (LRMI) is advantageous for the fabrication of ceramic matrix composites (CMCs). However, residual metal in CMCs ...

Effect of heat treatment on the microstructure and ablation performance of C/C–SiC composites containing ZrSi2–Si. Check for updates. Tianxing Jiang,a Yi Zeng ...

Effect of heat treatment on the microstructure and ablation ... - NCBI

The ablation rates of the composites after heat treatment for 20 h were lower than those of the samples after heat treatment for 30 and 10 h.

(PDF) Effect of heat treatment on the microstructure and ablation ...

ArticlePDF Available. Effect of heat treatment on the microstructure and ablation performance of C/C–SiC composites containing ZrSi 2 –Si. Royal Society of ...

Effect of heat treatment on the microstructure and high temperature ...

The effects of heat treatment on the microstructure and high-temperature oxidation of selective laser melted TiC/IN625 nanocomposites were studied.

The influence of heat treatment on the ablation behavior of the C/Cx ...

This paper reports that the composites could exhibit even better anti ablation properties after heat treatment. The materials were heat-treated ...

Effect of induction heat treatment on microstructure, mechanical and ...

Induction solution heat treatment can change the mechanical characteristics and corrosion resistance properties of 308 L manufactured via wire arc additive ...

Effect of heat treatment on the microstructure and ablation ... - OUCI

C/C–SiC composites containing ZrSi 2 –Si were prepared using low-temperature reactive melt infiltration (LRMI) at 1400 °C, and the thermal chemical ablation ...

Effect of heat treatment on the microstructure and ablation ... - CoLab

C/C–SiC composites containing ZrSi2–Si were prepared using low-temperature reactive melt infiltration (LRMI) at 1400 °C, and the thermal chemical ablation ...

Effect of Heat Treatment on the Microstructure and Phase ... - MDPI

The porosity (~1%) of the coating did not change after heat treatment. Thin, continuous, silica-rich film covered the surfaces of ZrO2 and Al2O3 particles, and ...

Microstructure, Thermophysical Property and Ablation Behavior of ...

After heat-treatment, both their open porosity and internal friction increase due to the fiber/matrix thermal expansion mismatch; while their thermal conductive ...

The Effect of Heat Treatment on the Microstructure and Mechanical ...

However, as the annealing temperature increased, the strength and hardness of the Al0.6CoFeNi2V0.5 high-entropy alloy samples gradually increased. This is ...

Effect of CNTs addition on microstructure, ablation property and ...

Addition of Si3N4 Strengthens SiC Coatings via Heat Treatment with Nitrogen Gas onto Carbon/Carbon Composites · Z. MaoLi Yang. Materials Science, Engineering.

Effect of high-temperature heat treatment on the microstructure and ...

Effect of high-temperature heat treatment on the microstructure and mechanical behavior of PIP-based C/C-SiC composites with SiC filler · List of references.

Arc Ablation Behavior and Microstructure Evolution of Plastically ...

After the heat treatment, microalloying and deformation, there are effects of solid solution strengthening, fine grain strengthening, precipitation ...

Effect of Thermal Treatment on the Microstructure of Polycrystalline ...

Abstract: The silver halide fibers were made by hot extrusion. The microstructure of the fibers changed after thermal treatment at different temperatures.

Microstructure and Ablation Behavior of Low-Pressure Plasma ...

The ablation performance test subjected to high-temperature plasma jet revealed that the linear ablation rate of ZrB2 coating increased with the ...

Effects of PyC shell thickness on the microstructure, ablation ...

When the thickness of PyC shell increased from 0 to 2.4 μm, the density and thermal conductivity of the composites was improved gradually, but the coefficient ...

Effect of substrate temperature and heat treatment on the ...

... ablation of graphite on a single ... Effect of substrate temperature and heat treatment on the microstructure of diamondlike carbon films ... The heat treatment ...

Heat impact during laser ablation extraction of mineralised tissue ...

Laser induced heating can cause denaturation of the collagen, resulting in ultrastructural loss which could affect mechanical testing results.