Getting Cannot Resolve URL for Protocol JMS When Non SSL Port ...

When the non-SSL listen ports are enabled and cluster address is configured to use only them in these conditions the issue cannot be seen.

Unable to find URL for hostID when disabling the non ssl ports in ...

When disabling the non SSL ports (using only SSL ports) completely in a JMS cluster, it fails and the following error occurs.

JMeter JMS: Getting Error: Failed to connect via SSL to [ssl://

I think you're using the wrong property (not only the wrong property but the wrong place as well), you're setting default protocol for HTTPS ...

JMS Client can't connect to server| JBoss.org Content Archive (Read ...

... this previous code works properly but i can't find the queue, i tried :.

ERROR: "javax.jms.JMSException:Failed to connect to broker URL ...

To resolve this issue, make sure that ActiveMQ JMS server is up and running.

Why Won't This Code Obtain a JMS ConnectionFactory? - JBoss.org

... can't be listed without another set. I mean until I know the JNDI ... .

Troubleshooting Remote Agents | Bamboo - Atlassian Documentation

The JMS protocol is used for other ... SSL JMS connector. Elastic agents JMS connector = primary JMS connector port number + 2.

Using the AMQ Core Protocol JMS Client - Red Hat Documentation

A receiving peer creates a consumer to receive messages. Like the producer, the consumer has a destination that identifies a source queue or ...

How to configure Weblogic JMS connector to connect over SSL ...

... without SSL but could not find any examples that used SSL or client certificates. Below is the non-SSL configuration of my connector:

Configuring Transports - ActiveMQ - The Apache Software Foundation!

Trying to use nio+ssl transport url on the client side will instantiate the regular SSL transport. ... If the client is not JMS you might want to look at REST or ...

JMS: What is the format of URL for SeeBeyond provider?

680.201] Cannot connect to the JNDI Provider: “seebeyond://dccdosse03.agc.local:24183”. [BRN.117.1012] URL Syntax Error: Missing protocol. The ...

Error and Status Codes - TIBCO Product Documentation

A client application attempted to connect to the server's TCP port using the SSL protocol. ... Could not resolve hostname '%s'. Possibly default hostname ...

3. Resolved and Known Issues | Red Hat Product Documentation

BZ#1153854 - Management Interface: SSL configuration does not allow disabling protocols. In previous versions of JBoss EAP 6, it was found that while it was ...

XGS 87 cannot resolve url - Discussions - Sophos Community

Important note about SSL ... When I use policy tester with the url, I get error device could not resolve the url, please update url and try again.

Running Harbor with HTTP behind a HTTPS Reverse Proxy (nginx)

... get harbor running behind (another) nginx reverse proxy. So the first setup looked like this: nginx (host,ssl) -> harbor-nginx(non-ssl) -> ...

External WebLogic clients :: WebLogic Kubernetes Operator

... port would not work if used to form a URL in the remote application. This is because remote EJB and JMS applications internally use their application's ...

Kafka Connect Security Basics | Confluent Documentation

If you have enabled TLS/SSL encryption in your Apache Kafka® cluster, then you must make sure that Kafka Connect is also configured for security.

Gatling HTTP protocol reference - protocol configuration

It supports HTTP and HTTPS with almost every existing feature of common browsers such as caching, cookies, redirect, etc. However, Gatling is not a browser: it ...

SSL Handshake Failures - Baeldung

Java system property for keystore does not support relative paths. Does this help us get the output we are expecting? Let's find out in the ...

Ports used by Atlassian Applications

Bamboo Server ports ; SSL JMS connector (primary JMS connector port number + 1), 54664, Closed/private (only required for remote agents ...