Events2Join

Has anyone had any trouble with their torque converter seal leaking


Has anyone had any trouble with their torque converter seal leaking

Has anyone had any trouble with their torque converter seal leaking? Just did a 5k trip and went through the rockies with a fifth wheel.

C6 transmission leaking at torque converter after seal replacement

I had a leak coming from the bell housing and I took the tranny out assuming the torque converter seal was leaking. The converter itself ...

leak coming from torque converter area - ThirdGen.Org

It is likely a front pump seal if it is leaking from the converter area. It could also be leaking from the torque converter itself, front pump o ring or the ...

Torque convertor leak-down - Vintage Mustang Forums

Converter leak down is a very common problem. Most transmissions have a check valve or check ball somewhere to help combat it.

Q&A: Fixing Torque Converter Seal Leak & Damage | JustAnswer

If the converter itself was leaking, there is a potential they could have caused it but it would have needed to be dropped. If the pump seal ...

Transmission leak around torque converter - Jeep Wrangler TJ Forum

If the leak is the dipstick or the pan seal I'd absolutely fix the leak and change the fluid. That is not money down the drain if it fixes your ...

leak at torque converter seal - Corvair Center Forum

I had the drive train separated during the 64 rebuild. Put all new seals and gaskets on everything. All in and running, but now I have ...

Transmission leak - Front seal ? or torque converter ... - YouTube

Always check your Torque converter before you install because you could have other problems that you would not expect so this video shows ...

Leaking from the torque converter? | Team Chevelle

The slit in the seal, if present may be visible by flexing the lip(s) with your finger and looking closely. If the converter condition does ...

Engine replaced and it's leaking transmission fluid? : r/askcarguys

There is a seal that if the torque converter can damage if it falls out. Normally if your careful the torque converter will stay in place when ...

Anyone had trouble with new torque converter seals?

The factor most greatly effecting these leaks is when the installer pushed the seal in too far. The face of the seal should be level with the casting face - You ...

01m leak from torque converter, someone with experience?

Did you replace the converter, as well as the seal? It's possible there may be a burr on the shaft, or it's just worn down enough so that the seal isn't ...

CVT Fluid leak from Torque Converter Seal - Drive Accord

The leaking problem is clearly manufacturer's defects, and they are just lying through their teeth and denying it through their graves until ...

Q&A: TORQUE CONVERTER SEAL LEAK - REPLACEMENT & FIXES

When the seal leaks, most of the time it is due to the bushing the converter rides on in the pump. When it wears, the converter wobbles and the seal leaks.

Failed Torque Converter Seal at 33k miles - CR-V Owners Club

The only thing I found online for why this would happen is because the transmission is overheating and damaging the seal.

Torque Converter Seal keeps leaking need advice please

I'll start with what I have done, originally I thought I had a bad engine oil leak but now I'm thinking it was the torque converter seal all ...

CVT Torque Converter Seal Leaking - Nissan Murano Forum

The lack of driving and the hotter months mixed with the extreme colder months maybe could contribute to the seal warping or degrading at such ...

Tranny still leaking after seal replacement - FEOA Forums

I think its possible a torque converter could have a leak that would be hard to spot; if it were along the welded seam. It would be pretty rare ...

Rear Main Seal Leak and Torque Converter Issue

If you have good eyesight and a dim flashlight, you're good to go on your own. Don't jump on the RMS/oil pan gasket bandwagon right off the bat.

leaking fluid from new gears and Torque converter, is this normal?

The fluid I think is transmission fluid. Is this normal after a new install like this after filling it up with new fluids for the TC and gears ...