Hose between intake and water pump

Do I need the hose between the intake and waterpump? - Chevy Talk

That hose is a bypass to allow some coolant circulation when the thermostat is closed. Its not necessary, but if you do get rid of it, make sure you have 2-3 ...

Bypass Hose from Water Pump to Intake - Team Chevelle

That hose provides a bypass for the coolant when the thermostat is closed and provides relief from air pockets in the cooling system. I closed ...

Hose between intake and waterpump - 332-428 Ford FE Engine ...

Real simple; cut the hose slightly shorter then the total distant between the pump and manifold. Put some lube on both nipples and on the inside ...

bbc,coolant hose pump to intake. - Hot Rod Forum

The hose is there as a bypass from engine to coolant pump when the thermostat is closed, it just routes through the heater as a convenience. Its ...

Water Pump Hoses & Strainers

Strainers attach to the intake of a water pump in order to sift through debris that may be too large to pass through the pump itself. These items ...

Intake Manifold/Water Pump Hose Connection - CorvetteForum

if your not worried about having a heater then just route the hose from the intake to the water pump or if your heater core is leaking it ...

hose between pump and intake manifold - Ford Truck Enthusiasts

Consider shortening the nipple on the pump. The figure the shortest hose you can get away with. Chamfer it a little. Lube it up and cuss at it ...

Larry Scott Asks… Is A Coolant Bypass Hose Really Necessary?

Larry Scott asks a question about the small bypass hose going from the front of the intake manifold to the water pump on a big-block Chevy.

Coolant line from intake to water pump on sbc? - NastyZ28.com

The hoses go from the water pump to the heater core and back from the heater core to the intake. One hose is 5/8 diameter and the other is 3/4 diameter.

1" Water Pump Intake Hose (20 Feet Long) - Walmart.com

1" Water Pump Intake Hose (20 Feet Long) · Free shipping · Free Holiday returns until Jan 31.

Water Pump To Intake Manifold Coolant Bypass Hose Direct Fit | eBay

Water Pump To Intake Manifold Coolant Bypass Hose Direct Fit ; MikesAutoPartsPDX (11895) ; Item description from the seller. Type: Coolant Bypass Hose. Product ...

Nipple Set, Bypass Hose Between Water Pump and Intake Manifold ...

Buy part #C-8866-41K Nipple Set, Bypass Hose Between Water Pump and Intake Manifold, Slotted, Concours reproduction for your classic vehicle from National ...

Daimler/Detroit Water Pump Inlet Hose DDE 08929875 | Diesel Dash

The Water Pump Inlet Hose seals the coolant flow from the radiator to the water pump. WHY IT MATTERS. The Water Pump Inlet Hose allows for coolant to flow ...

Whats the Water pump to intake hose called?

Any auto parts store should have the by-pass hose, but as Sac69 said, you have to trim them a little to make them fit. VMF Jedi Knight who's ...

Hose from waterpump passing under intake manifold

It comes out on the passenger side rear of the motor. The hose is bolted to the head with a bracket. There is not a lot of room to get the hose ...

Intake to water pump Bypass fitting - Ford Forums

Using 3 clamps on the new hose is a good idea. The lower bolt on the right (pass) side goes into coolant so use a little sealer on the bolt ...

Bypass Hose Water Pump to Intake AMC V8

Bypass hose that runs from the water pump to the intake manifold. Fits 1972-1983 Wagoneer; Fits 1984-1991 Grand Wagoneer; Fits 1974-1983 Cherokee; Fits 1972 ...

Intake to water pump hose for air gap intake??

you can buy a brass or galvanized steel fitting from home depot or any hardware store.. trying to remember size.

Hose between intake and water pump - 429-460

Whats it for? And do you have to run it? 460bronco wrote:Whats it for? And do you have to run it? It is a by-pass to relieve water pressure ...

Waterpump/Intake/Heater hose questions | Team Camaro Tech

The fitting on the intake manifold is the outlet, and that hose goes to the lower fitting on the heater core; the hose from the upper fitting on ...