Ideas on how to get wiring to the roof!

Run the wire up through a door when you need to plug the lights in. When not in use, unplug, coil up, and tuck away somewhere inside.

You can jump to 1:22 to skip the backstory/explanation -- I wasn't happy with any of the approaches I had found to run wiring up to my roof, ...

The best way is to go around the roof, not through it. As soon as you have a hole, you are providing a path for water. You can seal it, ...

You could always run the wires up the inside of the "B" pillar. Then take it to the roof from the top of the door to avoid drilling the roof.

*To run wires through the roof I DO NOT recommend just putting the wires through a hole in sheet metal and siliconing. Too much of a risk that ...

I probably already know the answer but I'm always open to learn other ideas that might be better than mine. But my array will be on an RV and I' ...

I have this idea of avoiding all roof penetrations, but that is challenging in practice. Forum member err posted some info in a thread about ...

Waterproof ways to run wires to roof lights. We show many options including how to use a supplied wiring harness, and how to build a DIY ...

There are numerous ways to run the cabling or wiring from the roof ... Traditionally we have always sheathed our wiring in convoluted ...

We focus on getting the wire out of the wall and into the ceiling ... 3 EASY WAYS TO HIDE WIRES CABLES IN WALL & FIND STUDS. TampaTec•4.3M ...

Run it down the a-pillar in a strip of wire hider, into the engine compartment. There's a grommet in there to get the wire through the firewall ...

I wanted to show you how I organized my Tacoma roof rack to protect and stabilize my wires in hopes they will have extended life.

but for the light bar, the wire harness will not work through that option. What other great ideas have people used in the past?

Two finished rooms your going to have to surface mount or cut floor above or the ceiling below. and drill holes only big enough for the wire to ...

Picture this: You have a super sick offroad rig, but you need some storage, and defiantly more light for your adventures.

I'm putting a front and rear light bar and have a Glass windshield. Any ideas would be great!

With wire running from the gland to a DC connector on the roof, with the roof rack removed you will have a dangling wire.

Running wiring is easy as pie in these things. Open up the roof jack. Peel off the sealant and there should be fasteners you can locate on each ...

You'll want a waterproof wire pass-through. Then you can run all the wires inside the car above the headliner and just have a penetration on the ...

I have installed literally hundreds of lightbars on police cars over the years and we always drill the roof, and leaks are exceptionally rare.