Left turn signal staying on...any ideas?

Left turn signal stays on constantly. I FOUND THE PROBLEM!!

Re: Left turn signal stays on constantly. Any ideas?? The switch is know to go bad. From reading other posts, there is a plastic piece that ...

Turn signals stay solid, and won't turn off on dash - LS1Tech.com

It would either blink really fast or stay solid. This was totally at random. My left turn signal stayed solid no matter what. Now they both stay ...

My left blinker is stuck ON | DSMtuners.com

Just make sure you keep turning left, all the time. ... But seriously, the cancelling cam inside the column prob broke.

Left turn signal stays lit - Third Generation F-Body Message Boards

Assuming the indicators are only lit with the car on, I'd start by pulling the turn b/u fuse and see what happens. Guessing, the problem will ...

Left turn signal staying lit on dash when head lights are on

The usual cause is a blown bulb, and usually the front blinker/marker bulb. So if one isn't working properly, check both front and rear bulbs on that side.

Left Turn signal stays on. - mr2 - Reddit

Pull your turn signal bulbs. On the bottom, if it has a single fillement it's the wrong bulb and will stay always on.

Left Blinker Problem and light stuck on - RS Warrior Forum

Turn on right signal and all three areas illuminate and flash normally. If this is correct, then either the front left turn signal bulb's ...

Left Turn Signal Light Stuck On - North American Motoring

If the directionals work on one side and not the other, but just stay on, it is usually the ground on that side (the one that just stays on) ...

Turn signal stays on solid when car is off! - Rennlist

The European Porsche's have a feature to allow the right or left front/back turn signal lights to illuminate for street parking to warn other ...

Q&A: TURN SIGNAL STUCK ON? LEFT BLINKER STUCK ON?

The most common issue is the turn signal switch failure. Of course this would have to be verified by doing some electrical testing.

Blinker indicator stays on solid when headlights are on? : r/askcarguys

This behavior is indicative of a bad bulb (or bad connection) so you're headed down the right path. If that doesn't work, checking (cleaning) ...

Typical issue. Left turn signal stays solid, but right turn ... - JustAnswer

Usually in GM vehicles, when one side blinker stays solid...that indicates a blown turn signal bulb on the side that stays solid. If you put ...

2002 blazer left turn signal light stays on

I'd look at the flasher unit, it's behind the glove box. Open the glove box & to the left there should be a plastic flap of sorts. Move it to ...

Left turn signal staying on...any ideas? - Hyundai Tiburon Forums

2003 signal stays on solid with the car off and key out......it is the BCM and nothing else...you probably got a bad BCM, they warrenty sure extend if the ...

Turn Signals Stay on instead of blinking | Kawasaki Motorcycle Forums

Usually that's a sign of a bad blinker relay if the fuses are OK. check the wiring and connections. is it both left and right sides that wont blink, or just ...

What would cause a solid turn signal indicator?

It sounds like you could have a faulty turn signal relay. A relay is a piece of electronics which flashes the light on demand.

Left turn lights stay on even with car turned off - AcuraZine

I'm just guessing but I'd start with replacing the blinker aka relay for your turn signal. Should be cheap part and fairly straightforward ...

Driver side turn signal stays on solid | Mercedes-Benz Forum

Is there truly a bulb out somewhere? Given all you have replaced, the problem is likely that the left turn signal circuit is not drawing enough ...

Turn signal stays on | GMC Yukon Forum | Cadillac Escalade

It could be the turn signal stalk/handle has an intermittent issue but I agree with the above... check all bulbs front and rear. A lot of times ...

my turn signal stays on - Honda Civic Forum

check your grounds! same thing happened to me except it was on the left blinker and my a/c didnt work. try to find out where the ground is ...