Reducing Sensitivity of Motion Sensor with a Mask

Reducing Sensitivity of Motion Sensor with a Mask - Wyze Forum

A mask made of translucent plastic such as used in milk bottles would dampen the Wyse motion sensor's sensitivity.

Reducing Sensitivity of Motion Sensor with a Mask - 2 - Wyze Forum

The revised method for making one only requires a few items found in the kitchen and your pocket or purse.

Outdoor motion sensor hack (electrical tape) : r/Hue - Reddit

The best way to reduce false positives is to face the sensor away from the source of them. For example, I had the same issue you had, along with ...

Success! Mechanical Motion Detection Zone Masking - Page 2

Point the camera right at one of your eyes so that your eye is in the area of the frame you want to mask. Then look straight at the motion ...

Reducing the sensitivity of a PIR sensor? - Electronics Stack Exchange

Remove the lens and put aluminum foil tape over a portion of the PIR sensor window, directly. The sensitivity is directly reduced by the area blocked.

Motion Sensor masking - Projects & Stories - SmartThings Community

Quite a few people have used that kind of masking on sensors. Your typically find those discussed in a specific project report. Some people also ...

Avoid Security Camera Motion Detection False Alarms

The lower the number the lower the sensitivity. the higher the number the higher the sensitivity. So the higher the number the easier the motion sensor will ...

Can you lower the sensor's sensitivity?

There isn't a programming option to lower an occupancy sensor's sensitivity in SSI. · The end user can use the following to lower sensitivity: Frosted Tape: ...

[Config Support]: is there any way I can tune down motion sensitivity ...

To be clear, I am talking about the motion sensors forget exposes to home assistant, not actually motion detection for recording clips.

Any way to further reduce the motion sensitivity - TP-Link Community

I did just try to shorten the distance of one of my other PIR sensors with a piece of semi-transparent tape over the sensor, however, I am going to do some more ...

How to Reduce False-Positive Motion Detection Events Caused by ...

1. Enable Person Detection · 2. Adjust Detection Zone and Sensitivity · 3. Adjust the angle and location of the camera · 4. Use a camera that has a ...

Motion Detection | Frigate

When possible, avoid creating motion masks that would block motion detection for objects you want to track even if they are in locations where you don't want ...

lighting - How to shape the zone a radar motion sensor detects?

Could the radar motion sensor's detection zone be shaped somehow? As the sensor is located on the ceiling, narrowing the detection cone would do ...

Solutions for pets triggering motion detectors? - Page 2 - Lounge

Covering the fresnel lens of the Xiaomi Mijia motion sensors with a piece of Scotch tape reduces their sensitivity.

I'm done with Zwave. Any zigbee motion sensors that can adjust ...

... motion sensor where the sensitivity can be adjusted? This is a must as I have pets which could set the sensors off if they can not be adjusted.

How to reduce the sensitivity of a motion sensor in a street light

Most motion sensors can be adjusted to some degree. Why are you tampering with a street light? or is the light on private property?

IQ Panel 4 - Panel Motion too sensitive - Surety Support Forum

I made sure that the panel motion sensitivity is set to low and put a few masks to decrease the recognition area. Other than just disabling it ...

SmartThings Motion Detector Range? I want to limit range so it can ...

Your idea of putting the PIR inside a box is a good one: You can put a slit or hole in the box in front of the PIR lens, and that could help ...

How to Adjust Motion Sensitivity for Motion Sensor - Tapo

After you have set up your motion sensor, you can go to the sensor's Settings page to adjust the motion sensitivity.

limit the range of PIR sensor | All About Circuits

I have also tried cover the sensor with combination of different color, and/or multiple layers, same result. I have also masked the sensor at ...