Replace Cam Phasers or not on a 2010 5.4 3V Triton?

They strongly suggested that the phasers don't need to be replaced, but change timing chain, guides and tensioner, along with a high volume oil pump.

2010 F150 5.4L Cam Phaser - Community of Ford Truck Fans

Mines made a ticking noise since I purchased my 2009 V8 5.4. A local mechanic said it was the cam phaser however advised me not to fix it since ...

Cam Phaser replacement, to do or not - Ford Truck Enthusiasts

The early 4.6L 3V and 5.4L 3V engines had issues with the cam phaser and lash adjusters. My were replaced under warranty at 25K miles.

Hi, just got this 2010 5.4 with a little over 150k miles. Have ... - Reddit

Between my dad and I, we had 3 of the 5.4 3V engines in F150's and an Expedition. They all had the chain slap and cam phaser rattle. Worked them ...

Ford 5.4L 3v Camshaft Phaser Replacement**UPDATED ... - YouTube

I put a paint mark on the chain where the r/L mark is, use the wedge tool, I take the second cam cap off, put a small piece of computer paper under the cap.

2009-10 5.4L Cam Phasers Still a Problem? - Ford F150 Forum

I assume this is normal (800 km on my truck) and am not worried about it, but when I googled 5.4 ticking of course I find zillions of people ...

Ford F150 5.4L 3v cam phasers - The Combine Forum

The whole job is not an insignificant cost - probably $2k in parts using Motorcraft phasers & chains, new Melling pump and aftermarket guides ...

Cam Phaser Replacement for 2010 F150 5.4 - Ford - JustAnswer

2010 f150 5.4 I had the camshaft phasers replaced 6 months ago due to over timing and rough idle eventually started.

2010 Ford F150 5.4L Timing Chain and Cam phaser - YouTube

How to Steps to replace the timing chain system and cam adjusters in your ford 5.4L and 4.6L engine with torque specs and tighten procedures ...

Ford 5.4 3V Cam Phaser Fix - Western Motorsports

Replacing phasers will sometimes cure the problem but often rattle comes back within a few months. The sure fix to phaser problems is to lock the variable cam ...

Ford 5.4 3 Valve Timing Chain & Cam Phaser Replacement - YouTube

In this episode, I work on replacing the timing set an cam phasers on the 5.4 in my 2006 Ford F150. Check out FordTechMakuloco's 4 part ...

Ford F150 Phaser Replacement Without Removing The ... - YouTube

This F-150 is just getting a new phaser. It is recommended to do a whole timing job but if all you need is the phaser this is how to do it.

2010 f150 5.4 triton | BobIsTheOilGuy

The cam phaser issue is going to come down to how the vehicle was maintained. The 5.4 3v likes clean oil and really likes a 5W30 more than the spec'd 5W20.

DIY - Cam Phaser Replacement - F150online Forums

The job took approximately 7 hours, which included an hour to pull the driver's side valve cover during reassembly after realizing the #8 injector plug had ...

Finally fixed my ticking 5.4 3v... cam phaser replacement...

Hmm. I posted when I was having ticking issues with our 5.4 Triton but received limited replies. The Dealer said to replace the Cam Phasers for ...

How to Replace Cam Phaser on Ford F150 - YouTube

2004-2010 Ford F150 Cam Phasers and Complete Timing Kit | How to Replace ...

CAM PHASER REPLACEMENT COST - EXPERT Q&A on FORD 5.4 ...

The engine does not need to be removed to do the timing chains. The exhaust manifolds would be 5 hours per side plug 1 hour for each broken ...

Ford 5.4L Cam Phaser and VVT Control Solenoid Replacement

Replacing the VVT sprocket on a Ford 5.4L engine is an in-depth job ... Ford 5.4L 3v Triton Engines: Always Check This First Before ...

Diagnosing VVT Cam Phaser Issues on Ford 5.4L V8 ... - YouTube

Comments43 ; Ford 5.4L 3v Timing Kit Choices: This is Why You NEVER Want to Use Aftermarket Camshaft Phasers! FordTechMakuloco · 157K views ; 2010 ...

How bad is the 5.4l 3v cam phaser issue? - SVTPerformance.com

Mine is a 2004 - and I did the whole chains / chain guards / phasers / VCT solenoids / oil pump upgrade myself. $1300-1500 for Ford parts and ...