Route traffic on different ports through different network interfaces

Connect the server to two network interfaces at the same time and route traffic depending on destination port.

How to route different traffic thru different network interfaces (in ...

This will send all the traffic for 10.183.x.x to the next hop address of 10.183.148.5 which your system already knows is off of your ethernet ...

Routing port traffic over specific interface

You cannot route incoming traffic. Other systems decide which traffic you get and where. Routing decisions affect outgoing traffic only. Your ...

How to route traffic through two different network adapters based on ...

@MariusMatutiae, yes, that's clear. The rule that I want to set is simple: all outbound TCP traffic for host1 on port 1935, use interface 1 ( ...

How to let different processes use different network interfaces?

You could try follow similar approach by running different process with different user and route traffic from one user to one uplink. Also ...

Route different traffic through different network interfaces (in Windows)

Use route or netsh to configure your routing table so that the route to your LAN subnet has a lower combined metric (interface+gateway) than the wildcard route ...

setting up routes between networks on different ports

What you would do is create the VLANs in Network. The routes are automatically created between the VLANs. Then assign VLANs as Native as required in Port ...

Best Practices for Using Multiple Network Interfaces (NICs) with NI ...

In other cases where gateways are attached to subnets that connect with different network interfaces, you can either manually specify network ...

Route Port 25 traffic through a different WAN Interface

We will send any incoming traffic from our LAN that is destined to port 25 to be sent towards interface Gi0/2. You can also do this via 'set ip next-hop' better ...

Configure routing for an additional network interface | VPC

This tutorial describes how to create a virtual machine (VM) instance with multiple network interfaces, each of which is attached to different Virtual Private ...

Routing multiple network interfaces - #6 by FredFerrell

When you configure a LAG/port-channel/Etherchannel (all different names for the same thing) it will have an algorithm that determines how ...

How does my computer decide what network interface to use for ...

If you have a route in the table on that other NIC, and you get traffic destined for that network, then the computer acts like a router and ...

Split traffic between network interface.. - Apple Support Community

You can't do this - at least not practically. Traffic routing is typically based on IP address, not port, so it would be possible to say 'send ...

Routing Between VLANs & Layer 3 Switches - Practical Networking

Router with Separate Physical Interfaces ... The simplest way to enable routing between the two VLANs to simply connect an additional port from each VLAN into a ...

Pass traffic from one network interface to another

This is more a common routing issue than belonging specifically to Raspberry Pi. Anyway, here are the manual routing settings because I ...

Routing multiple network interfaces - Lawrence Systems Forums

If on the switch you only allow the VLAN that matches the network that port is on, it'll guarantee that traffic is split across links. Also, you ...

How to route traffic between interfaces on same router

10.1 so all inside traffic goes out. Both networks have clients on them, but only the 10.10.10.100 network has an internet connection through another device on ...

Route traffic over specific interface | Ubiquiti Community

If your service can use different destination ports at the source then you can possibly use PBR based on destination port (along with source IP) and use DNAT to ...

Routing between 2 internal ports in fortigate 60c - Security

You need to configure a policy allowing traffic between those two ports. There is a deny rule for any traffic that doesn't match any rules you have configured.

Chapter 27. Reusing the same IP address on different interfaces

For that, VRF partitions a network at layer 3. This enables the administrator to isolate traffic using separate and independent route tables per VRF domain.