Tighten or replace trans cooler line fitting at radiator

Tighten or replace trans cooler line fitting at radiator - Saturn Forum

Saturn S Series Sedan - Tighten or replace trans cooler line fitting at radiator - The top transmission cooler line leaks at the screw in ...

How much is too much tightening? Tranny coolant line

I'd say anything over 20 Foot Pounds is excessive. Always use 2 wrenches when tightening the trans lines at the radiator, one to hold the ...

Quick fix for leaking tranny cooler fitting at radiator

For a "quick fix", just pull both ends out of the radiator and loop them with some trans cooler rated hose. Its not ideal but can be done in a few minutes.

Help Needed - Transmission Cooler Radiator Fittings - MBWorld

When I screw the male fitting back in place just gentle pressure on the thread causes transmission fluid to gush out around the outer edge of ...

Help!! Transmission line fittings that go into radiator - Duramax Forum

DO NOT remove both external fittings at the same time, or the cooler will come loose, and the internal orings will shift, and your totally ...

Torque # for fittings, radiator/tranny lines - Ford Truck Enthusiasts

20 lb-ft on the cooler lines and 25-35 lb-ft on the mount bracket bolts. A little pipe dope should do the trick.

How To Fix Damaged Transmission Cooler Line (Andy's Garage

Andy Phillips shows how to repair damaged transmission cooler line where it connects to the radiator. Below are links to other videos of ...

Technique for installing GM Oil/Trans cooler quick connects on new ...

Installed radiator today with no issues. I just pulled the clips off the old ones to remove and lubed up/pushed the lines into the new fittings ...

Need helps with radiator transmission cooler fitting - LS1Tech.com

right now I am trying to make hard lines work and it's becoming a pain. I have a 2000 LS1 style radiator for a camaro and a 4L60e with the push ...

How to Replace Transmission Oil Cooler Connector 2005-2010 ...

... Transmission cooling lines deliver and return transmission fluid between the transmission and radiator to keep the fluid at a proper ...

Oil and transmission cooler fitting to radiator torque spec | S-10 Forum

I always tightened until it stops and then give it a good snug similar to an oil drain plug, really not tight at all. Not sure if a torque spec is available.

Lower transmission line leak at radiator bolt: trick to tighten and seal?

I reattached the nut/collar, paying attention to how 'direct/straight' the fitting was. I tightened it as tight as I could, and again, slathered ...

Transmission cooler line leak at radiator fitting

When you turned the large hex fitting, the smaller moved because it's tightened against the larger. What you could've done is loosen the small ...

Transmission cooling line leak at radiator from connection

Being a flare fitting, I would remove and closely inspect the sealing surfaces for nicks or scratches. Thanks. Reactions: Hellshalfacre.

Transmission line to radiator leaking...advice - Chevy Tri Five Forum

Take the fitting off the radiator and inspect the flare and seat for nicks or foreign matter. If those are not present, sometimes an inverted flare will seal ...

New Radiator ATF Cooler Lines Adjustable??? YES. SOLVED

Yes those are compression type fittings. You just clock it to where you want it and then tighten it down. Like.

Transmission cooling line popping out of radiator

Make sure the cooler line goes into the fitting perfectly straight, so that the flange on the line clicks behind all three points of the retaining ring.

Trans fitting at lower right on radiator: little drip. - Tacoma World

But, if tightening the fitting stopped the drip, you may want to consider removing the fitting and reinstalling with silicone tape on the ...

Trans Cooler Line Lower Radiator Fitting - DodgeForum.com

There's this fitting on the radiator (passenger side) that is just a stub for the push connect fitting for the trans cooling lines. Well, that stub is broken.

Trans cooler line size on radiator - ThirdGen.Org

Do yourself a favor and get rid of the hard lines. Not having to wrestle with the hard lines when all you want to do is pull the radiator, or ...