Transmission cooler line connector fitting leaking

Transmission Cooler Quick Connector Leaking

It sounds like you are disconnecting the lines at the Transmission. You don't need to do that. Just disconnect at the Radiator, plug the end in ...

New radiator installed - trans fluid leaking out the cooler line fittings.

It is enough to create a steady stream of transmission fluid that leaks both down the side of the radiator and down the right hand side of the fan shroud.

Transmission Cooler line leaking at quick connect fitting

I would just replace the fittings with OEM. 05 Taurus SEL Duratec - my daily driver 04 Taurus SES Duratec - wifes car - TOTALED 06 ...

Transmission cooling line leak at radiator from connection

It's a transmission cooling hose fitting that is leaking out of the back of the connection (photo attached). This is a new hose that my mechanic put on.

What does fixing a leaky transmission cooler fitting typically consist of?

I'd start by disconnecting the rubber hose and removing the threaded fitting. Of course you'll need a pail to catch the fluid. Once the fitting ...

Quick fix for leaking tranny cooler fitting at radiator

My transmission cooler line is leaking at the fitting where it enters the radiator.... It uses that ridiculous quick disconnect fitting GM ...

Help! Transmission Cooler line leaking? - YouTube

I had 2 leaks from the same hose fittings on my 89 jeep XJ, did not want to go get new lines, instead got 2 steel hose clamps from home ...

How to fix tranny cooler line outlet fitting leak - Hot Rod Forum

Fortunately had a new fitting on hand and that fixed it. Be sure the line's not scored. If it is, you likely won't stop it leaking without a new ...

So I have a leak from the transmission cooler lines - Reddit

When it leaks has the line backed off, ie. loosened? If it will twist easily that's the issue. Perhaps the line has stored twist in it that's ...

Transmission cooler line fitting leak - Jeep Wrangler Forum

iirc there are brass fittings threaded into the case and then the cooler lines thread into those.... if that is the case then he would have ...

Trans. cooling lines won't stop leaking - CorvetteForum

Those fittings seal via the flare joint. If you put [slippery] teflon tape on pipe threads and tighten them up, most likely the threads will ...

New tranny cooler lines leak !!! | BobIsTheOilGuy

You may have a deformation in the flare or the seat on the brass fitting. I would pull the flare fitting out, inspect the male & female ends for ...

Leaking transmission cooler line fitting | Chevy Silverado and GMC ...

Tube is properly fitted. Wire snap ring in place. Plastic retainer also in place. Replaced the “O” ring in the fitting with no name O ring.

Leaking transmission cooler fittings - Subaru Outback Forums

If it was leaking coolant, then I'd suspect the fitting on the radiator. Since radiator end tanks are composite or thin brass , I would not ...

Transmission line to radiator leaking...advice - Chevy Tri Five Forum

Teflon tape only works on pipe thread. Most auto trans cooler fittings in a radiator tank are inverted flare. They seal because the flare on the ...

Trans cooler fittings leaking, do I need to drain it first?

Perhaps the plastic clips have worn or the internal o-rings are no longer sealing? With our radiator, the factory transmission line fittings ...

transmission cooler hose leaks | Cummins Diesel Forum

If that one is leaking, the oil will come out between the fitting and the cooler line. Or, as HVYDTY noted, you could have a hole in the cooler ...

Transmission oil cooler line connector leak | S-10 Forum

mine was not on there which is what caused the line to pop out. just make sure you got the right fittings and the adapters and it should seal up ...

Fixing Leaking Transmission Line Fittings at Radiator - JustAnswer

It is leaking where the metal fitting meets the radiator. Can these fittings be removed, sealed, and reinstalled?

Tranny Cooling Line Fittings Leaking At New Rad | BobIsTheOilGuy

The upper tranny coolant line fitting started leaking quite a bit. I torqued them down a little tighter, but no improvement. I took them apart to inspect and ...