Transmission hose line diameter
transmission cooler hose size | For A Bodies Only Mopar Forum
thank you for all your help. I do think I will buy the 5/16 line because the fitting that goes into the 1/4 hose is small compared to the 5/16 ...
Transmission Cooler Hoses: Is Correct Inside Diameter - 5/16” or 11 ...
I see a lot of people use 5/16” hose when replacing the lines which run from the transmission to the radiator. However, I have read 11/32” is the correct size.
What size lines for trans cooler? | Yellow Bullet Forums
Use a 3/8" line. If that is too much trouble, use the factory 5/16" lines. Larger lines will have less restriction over its length than the smaller lines.
Transmission line size - The Ford Torino Page Forum
Most older Fords had 5/16" lines, but 3/8" lines are much better. Ford learned and upgraded all trans lines sometime in the 1980's, the smaller lines restrict ...
Transmission cooler line size? - ClubLexus - Lexus Forum Discussion
IS F (2008-2014) - Transmission cooler line size? - Hi, I just wanted to know what was the ID of the hoses between the transmission and the ...
What size is the automatic transmission cooler hose? | Tacoma World
3/8ths. Ive never seen a tranny cooler setup on passenger vehicles that wasn't 3/8ths. anywhere from civics to f250s. even their power steering lines are 3/8 ...
What inside diameter is the transmission hose - Nissan Frontier Forum
Just get about 2' of 5/16" trans cooler hose, two 5/16" caps to put on the radiator fittings and some small hose clamps. I usually use brake ...
Sizes: trans cooler hoses | IH8MUD Forum
Just as an FYI the small vacuum hoses used in the engine bay are metric in size, not SAE. Most auto parts stores will try to sell you SAE hose, ...
Trans cooler line routing? Line size? - LS1Tech.com
The consensus was that 5/16" is plenty. If you decide to use AN hoses, a size AN6 gives even more capacity.
Transmission hose size | Honda Odyssey Forum
Short answer: Your Odyssey uses 3/8" ID hose, from tranny to radiator in-tank ATF cooler and back to tranny. The Long Tru-Cool 4452 has 11/32" hose nibs, but 3 ...
Transmission hose line diameter | Second Generation Nissan Xterra ...
The lines are 5/16". I used a 5/16" Magnefine filter and it fit fine. I am sure you will be able to get the 3/8" on with a little extra work. I ...
transmission cooler line size? | The Diesel Stop
The proper hose is "transmission oil cooler" (TOC) hose. It will be marked on the casing along with possibly the SAE J1532 spec. The diameter is usually 11/32".
Transmission cooler hose sizes? - The Chrysler Minivan Fan Club
The fittings at the trans on the 31th and 41te are both 1/8" NPT X 5/16" hose nipple. Careful if you are trying to unscrew the fittings on the trans cooler in ...
Transmission cooler line size | GMT400 - GMT400
It's usually 3/8" OD. There is a port on the driver side of the transmission right above the shifter shaft. It's 1/8" npt and a sensor will ...
Tranny cooler line size, fittings, and pressure drop. | Pirate 4x4
Most cheap tranny coolers you see are for 3/8 SAE hose. Based on this, one might conclude that -6 AN hose would be sufficient for the cooler lines.
Transmission cooler rubber hose size - Ranger-Forums
3/8's ID hose is what you want, and high temp hose not high pressure. The trans cooler lines don't have pressure, there is a lot of flow so some pressure just ...
Rubber trans. oil cooler hose 3/8" or 11/32" diameter?? - Jeep Forum
The steel lines themselves are 3/8 diameter and have a bulge in them to keep the hose form slipping off. 3/8 hose will be easier to install.
Transmission line size (-6AN or -8AN) - CorvetteForum
The factory steel lines are 3/8 which is a 6AN. LoneStarFRC's Avatar. LoneStarFRC 05-29-2011 10: ...
Transmission cooler line size - Vintage Mustang Forums
1- Would it benefit or hurt the transmission to increase the cooler line diameter from the stock size (I think 5/16) to a 3/8 larger line?
Transmission line tubing size | Ford Mustang Forum
The stock trans lines are 5/16 inch. If you are going to run fuel lines on a 2 barrel stock engine 5/16 inch will be OK, but if there are any ...