What is correct ohms resistance of throttle position sensor on 2003 ...

the resistant range they give of 3.5 - 6.5 kilo-ohms is between pins 1 and 2, and is just a general check to see if the value falls within that ...

Yes, the resistance will be different if you test the sensor on the bench compared to it being mounted to the throttle body.

Hello, I tested my TPS yesterday with volt meter and when I did the test to see how it responds it sat at 565 ohms when I rotated it went up ...

When you opened the throttle, the meter reading changed to 1.46K (1,460 ohms), about 1/9 of the proper value. You had the meter on the wrong ...

Does anyone know ohm or resistance reading when the throttle position sensors are fully closed versus fully open. Necessary for bench testing ...

Checking both sensors, each goes through a smooth resistance change as the potentiometers are rotated. Both sensors start at 4.7K-ohms with ...

Here is a video on how to test a throttle position sensor with a basic multimeter, I also show you how to do this without a wiring diagram.

Resistance at closed throttle should be 3-4K Ohms, and 350 Ohms at wide open. ... position, resistance, sensor, test, testing, throttle, tps, ...

In the workshop manual the specified values for the tps are (quote from manual): - "THROTTLE POSITION SENSOR (TPS) Resistance across VTA ...

Set your multimeter to ohms. Connect the ohmmeter probes to the sensor's supply and signal wire contacts. Manually open and close the throttle ...

That means once the resistance reaches 2000 ohms (2.0 on the meter) you go out of range. you need to be testing on the next higher resistance ...

Half way open throttle, it is about 1.70 ohms. ... --While slowly opening the throttle, check that the throttle position sensor resistance is ...

Tags 2003, accelerator, adjust, code, evo, lancer, mitsubishi, ohm, ohms, position, resistance, sensor, set, throttle, tps · Subscribe. Related ...

Wide open throttle 4.0 to 4.5 volts. Resistance between A and B terminals (top 2) terminals 500 ohms throttle open, 3000 ohms throttle closed. % ...

I decided to check my TPS. I removed my TPS, took my multimeter and put the leads on the B and C connectors. I get a reading of 2k ohms, as I ...

There are no resistance specifications for the throttle position sensor. You can measure voltage output of the sensor with a voltmeter.

The ECU doesn't actually use the resistance of the TPS but only its output voltage which should be 0.4 - 0.6 V at idle and 4.5 - 5.5 V at WOT.

If it reads over 1 ohm, or if the value doesn't change, you have the wrong pin. Keep the red one in the center and check the other outside pin.

... Proper safety precautions are always needed, and are the ... How to test throttle position sensor wiring with a resistor (any car).

A-C should read about 5000 ohms no matter what the throttle position. B-C you don't really care about but will be have a high reading at idle ...