What to replace while Im replacing the torque converter

What else should I replace when the torque converter - Tacoma World

My torque converter is trashed and I will be replacing it soon. I am going to replace the engine rear main seal while I'm there.

I would just replace the converter, change the fluid and filter. The pan gasket may be reusable if its metal or hard plastic. Do not use a cork gasket or ...

What else to replace when doing the Torque Converter and...

What else to replace when doing the Torque Converter and Transmission Pump? ... First off, TLDR at bottom, Long Story Short up here. To all the ...

What all do I need to buy when installing new transmission and ...

Ensure you put transmission fluid in the torque converter (TC) prior to installation. If you put it in the transmission dry, you will destroy it ...

How hard is it to replace a torque converter on your own? - Reddit

Replacing the torque converter isn't too bad. The big part is getting to it. You need to drop the transmission off the back of the engine to gain access to it.

Engine being removed to replace Torque Converter, what...

In addition to what you mentioned I'd do water pump, thermostat, valve cover gaskets, cam/crank seals, serpentine belt, all idlers/tensioners.

Don't know what peripheral parts are needed to replace to...

... I'm ... replacement "while you're in there". These are inexpensive parts compared to the labor cost and effort to replace the torque converter.

WATCH THIS BEFORE REPLACING YOUR TRANSMISSION!!

... when working on vehicles and or with tools seen or ... 6 Bad Torque Converter Symptoms and Replacement Cost | Signs Torque Converter is BAD.

Torque Converter Replacement: What It Entails, Cost, and FAQs

You will remove the torque converter, inspect the new converter's seal before flushing it with automatic transmission fluid (ATF), ...

Can you replace just the torque converter in a transmission? - Quora

Of course you can. It is the first thing you remove when you take out a auto transmission and the last thing you refit before you reinstall a ...

A6, 4.2l; replacing torque converter, what else should I ... - AudiWorld

Thats true, its all depends on how much you like the car and how much you are willing to spend. ... So i would definitely replace rear main seal, ...

When rebuilding the engine, should the torque converter be replaced?

okay, you all know I'm in the middle of a rebuild of the 4.0 for my 1995 XJ. I just got the short-block back. Along with some paperwork and ...

Replacing Torque Converter in Transmission: Q&A Guide

To replace the converter, you will need to remove the transmission. This is not a horrible job if you have the access to a lift and a transmission jack.

Replacing my torque converter, need help in which one to use

you shouldn't need to care for those numbers. Asking for a OEM replacement Torque Converter for your year/trans should get you what you need.

How To Properly Install A Torque Converter - YouTube

Hughes Performance Torque Converters - Today we're covering how to properly install a torque converter into an automatic transmission.

Always replace torque converter when rebuilding transmission?

I would replace the torque converter. You can order one from Transtar. Air compressor should be used with a good dryer as the air packs a lot of moisture.

Removing and installing new torque converter - GMTNation

Also, I consider changing a torque converter to be a medium to high level difficulty job. You'll need to have plenty of knuckle/flex sockets ...

Rebuilt transmission- replace torque converter? - EricTheCarGuy

They want to completely rule out that their transmission is bad in case something happens. The main thing you need is a receipt or purchase ...

Transmission rebuild, Torque converter needs to be replaced?

So I've been searching the forums, YouTube and the net for information, and I'm going to be tackling the transmission myself.

Do you need to flush a Torque converter when replacing a slipping ...

I replaced the torque converter to avoid circulating any contamination through the fresh rebuild. I also flushed the trans cooler to remove any ...