hose between pump and intake manifold

Do I need the hose between the intake and waterpump? - Chevy Talk

Originally it looks like it should be a hose between the intake manifold and the waterpump. Not sure why it is there, but probably so there ...

hose between pump and intake manifold - Ford Truck Enthusiasts

Cut the "by-pass" hose from a piece of 5/8" heater hose. Lotsa luck attempting to install the by-pass hose without removing the waterpump. You ...

Hose between intake and waterpump - 332-428 Ford FE Engine ...

On the length of the tube coming out of the intake manifold. Some of them are so close to the tube coming out of the water pump that there ...

Water Pump To Intake Manifold Coolant Bypass Hose Direct Fit | eBay

Great communication from the seller. Will definitely purchase from this seller again. GSP Rear Wheel Hub with 5 Lugs 1 each Direct Fit (#235499089301).

Bypass Hose from Water Pump to Intake - Team Chevelle

... intake manifold with one that moves the bypass fitting. Short water pumps place the fittings 90 to each other. Long water pumps place the ...

Intake Manifold/Water Pump Hose Connection - CorvetteForum

C3 Tech/Performance - Intake Manifold/Water Pump Hose Connection - What is the advantage/disadvantage of the coolant hose connection between ...

bbc,coolant hose pump to intake. - Hot Rod Forum

Appx 3/4 "hose from top of water pump to intake manifold(front).? Is if heater has been removed as well as hoses is this small 3"in length ...

What is this hose running from the intake to the exhaust manifold for ...

It routes air coming through the heat riser shield around the exhaust manifold up and into the air cleaner and to the carb to keep it from icing up.

Nipple Set, Bypass Hose Between Water Pump and Intake Manifold ...

Buy part #C-8866-41K Nipple Set, Bypass Hose Between Water Pump and Intake Manifold, Slotted, Concours reproduction for your classic vehicle from National ...

Hose, Bypass For Water Pump To Intake Manifold Gm 5.7L

Pinterest. Overview. Product Description. NOTE: We ship direct either from the factory or from our stocked inventory in Bristol, PA. Please feel free to ...

Larry Scott Asks… Is A Coolant Bypass Hose Really Necessary?

Larry Scott asks a question about the small bypass hose going from the front of the intake manifold to the water pump on a big-block Chevy.

Hose Bypass For GM Big Block V8 Water Pump to Intake 32-805987

This hose goes from the top of the circulating pump to the intake manifold. Fits all 454 7.4 and 8.2 502 engines regardless of brand that use this hose.

BBC OEM water pump bypass hose to manifold - Yellow Bullet Forums

What was the original purpose of the small 90 degree water hose that went from the top of the water pump to the front of the intake manifold ...

Hose from waterpump passing under intake manifold

The hose just blew at the point where it attaches to the back of the water pump. It disappears out of sight going toward the rear under the ...

Intake to water pump hose for air gap intake??

The small hose that goes between. Anyone know what ... go over to mancini and tell them you need the intake manifold bypass hose fitting.

Coolant hose under the intake? (DIY procedure included!)

1 - With the intake plenum removed, proceed to remove the Secondary Air Pump. 3X Torx Screws must be removed and Disconnect the plug. 2 ...

Heater hose connection at intake manifold - NastyZ28.com

Like COPO said, heater hoses are straight. If you have a big block, there is a 090* hose from water pump to intake manifold.

intake heater hose??? 258 - Jeep Forum

Where do I get one of the hoses that goes from the water pump to the front of the intake? ... intake manifold on a 1979 304 V8? Ron 79 CJ5 ...

Water pump / manifold hose connection | NastyZ28.com

I have a cast iron replacement water pump from Jegs, and a Weiand intake that has a raised plenum where the water neck is.

Coolant bypass hose? | For A Bodies Only Mopar Forum

No not for the heater. Its that little hose about 5" long that goes from the intake manifold to the water pump.