lifting the cab off the frame by hand

My gutted 81 caqb was light enough that I was able to lift it by hand at the rockers, one side at a time. Lift and kick a horse under that ...

... hands – just you, your tools, and a bit of know ... 1941 Chevy Truck, Modify the engine hoist to lift the cab off the frame from the side.

Once the cab is supported, lower the frame and roll it away. If the tires are too tall to slide under the cab, then take 'em off and put a floor ...

We wiggled the cab as far as possible to the PS and then gently tipped and slid it off the frame so the PS rocker was on the ground. I came ...

In this video I show you how I installed my truck cab with no lift and discuss some other methods.

It's time to put my Square Body cab back on the frame. Problem is, I have no idea how to accomplish this without getting hurt. To remove it, we ...

We used an engine lift to take my cab off, which was relatively easy to do ... as the cab was completely stripped. Doors off, windshield and ...

Then you can unbolt the steering box from frame and finagle it all out from the bottom. Of course steering wheel and column support must be off.

This may sound a bit odd but I took one off by my self. I un-did the bolts then jacked up the cab over the height of the tires and rolled the ...

do you have a cherry picker? easy peasy with a custom lifting jig, just screw some short 2x4 to the center of a 4x4 that is longer than the ...

I build the cab cart and jig to lift the cab off the fame so I can start to clean it up and make it purtty!!!

... lift so my best option to remove the cab required me to build ... How to remove a Chevy truck cab from the frame. Station road Rat rods ...

Removing the cab from my Silverado and gutting it to appease the cab swap "experts" ... Repairing a Rusty Frame on a GMT800 Truck [Cheap Duramax ...

I have seen a lot of different posts on getting a pickup cab off of the frame so thought I would share my method ... hands to help pick it up.

From what I have read on this and other forums, people use a high lift to jack up each side and use planks to support the cab, repeating the ...

Today Mikey @theshopspot9053 and I will be installing the cab onto the restored southern frame of my 1980 Toyota Pickup Long Bed.

How to make a cheap tool to remove a vehicle body from its frame. This tool cost under £60 to make, and means you can remove a body from a ...

... frame without any type of lifting device. The cab is ... I don't envy any of you removing cabs from your trucks. Just looking at that 5 ...

You should only need to cut 2 rafters and that would give you a 6 foot wide hole to send the cab up through. The hood would just go up against ...

Just 4 bolts holding the single cab to the frame. If you plan on leaving the interior intact, doors installed, etc. then you'll want a 4 ...