where does the o ring go on a cooler line fitting?

where does the o ring go on a cooler line fitting? - Ranger-Forums

The idea is that by the o ring being around the outlet nipple at the bottom of the brass fitting and the flange end of the cooler line it would ...

Oil Cooler Lines - Should there be O-Rings on the Fittings?

yup. These are regular Viton o-rings you can get at the hardware store. If I recall, they're 1/16th x 1/2 inch ...

Replacement trans cooler line o-rings? - SteelSoldiers

Do the lines themselves typically fail (e.g. split or wear through), or does the o-ring just go? This is a stead run of ATF out of the compression nut, like ...

Trans cooler line fitting O-ring? - Third Generation F-Body Message ...

None of the factory fittings are O-ring. The lines are 5/16" inverted flare. You need that adapter instead of the one you have.

4L60E Auto Transmission Push-In Cooling Line O`Ring Seal How to ...

Replacing 4L60E Auto Trans Push in type Cooling Line rubber oring seal, make sure you replace it if you remove the transmission to avoid ...

Oil Cooler Hose Connecting O-rings - Matthews Volvo Site

The o-ring is #27 and the sealing ring (clear) is #28. The #28 basically goes at the base of the hose fitting. Also make sure the clamp is in the correct ...

Oil Cooler Lines O-Rings | Diesel Place

Inside the fitting is an o-ring. I pried that o-ring out and went to O'Reilly's and Auto Zone to either buy the o-ring, o-ring kit for all ...

Cooler Line Seal Installation Type 2 - YouTube

Cooler Line Seal Installation Type 2. 491 views · 6 months ago ... Go to channel · If You've Got an Old Car, Do This Now. Scotty Kilmer ...

Transmission line fitting at radiator (seal?) - Ford Truck Enthusiasts

1999 - 2003 7.3L Power Stroke Diesel - Transmission line fitting at radiator (seal?) - Is there an oring or something that is supposed to go ...

O-rings, flat practice washer in the end of transmission fluid cooler line

So I went through a couple of O-ring orders from Amazon but settled on the 19mm OD X 14mm ID (2.5 mm thick obviously) for the two rings on ...

Transmission cooler line o-ring - Club Touareg Forum

you could try putting the o-ring in your freezer to see if it will shrink some. Place in the hole and when it warms and expands in the cavity ...

Transmission Cooler line O rings? | NAXJA Forums

If you want to use an o-ring you can go down to NAPA with your part and they will help you find one. They have a box with 30 different sizes and ...

Transmission Cooling Line O ring replacement on a Ford Windstar ...

How to remove a Transmission cooling line without damaging the plastic clip in the radiator extension housing. O ring set: ...

Oil Cooler Line O-Rings - Chevy Message Forum

It has the lines that push in to o-rings in the oil filter cooler adapter and are retained by the plastic clips. The new lines do not come with ...

o rings on transmission lines? - Full Size Ford Bronco Forum

fitting) and reinstall, turning snugly but DO NOT REEF ON IT. The fitting and the cooler are brass and can easily strip. Now put the line ...

Trans Cooler Line Quick Disconnect O ring Question

The lower one was not what I expected (feed line I believe?). I had ordered new fittings for the type that has the little wings that you pinch ...

Transmission line o rings - DodgeForum.com

No, the O-Rings do the sealing. I forget the name of the fitting, but it's similar to 37 degree AN fittings. Self sealing, dry threads.

Oil Cooler Lines/Fittings - BangShift.com

So when all else fails, go to the dealer. The steel fittings are dealer only, with non serviceable o rings. There is a plastic bushing that is ...

HELP! Oil Cooler Line. - Chevy Talk

I do have the kit for the filter adapter and I have read to replace all the O-rings. BUT for now I'd like to get this finished...so I will have ...

Transmission Cooler Line ? O Rings | Cadillac Owners Forum

I'd guess around a pint tops? Stick a rag under the fitting, pull the line off at the trans, slap your thumb over it, then direct it into a ...