Heater hose removal at manifold fitting ?

Heater hose plumbing question. - Ford Muscle Forums

Then remove the plug to the left and install the fitting for the heater hose. ... remove the manifold. The bypass tube should be available ...

Heater hose connector failure. - Hummer4x4Offroad

Ah, I might be lucky and not blown the motor and just blew a manifold gasket. ... Plastic fitting just fell apart when I tried to remove it with a ...

Help on Eliminating Coolant Lines on Intake Manifold - www.ka-t.org

I have no problem taking my manifold off with the hose this way. If you go under the entire manifold you will need 90* fittings so the hose wont ...

Under intake heater hose replacement - Lincolns OnLine

I just had my hose replace literally like...3 hours ago. All me and my friend did was take the original "pipe" out, saw the busted hose off at ...

Broken Heater Hose nipple on my PI intake! - Crownvic.net

It's basically a heater hose connector hammered down into the intake manifold. ... If / When I replace my manifold I will also get all new coolant ...

How to remove pipe-to-manifold coolant hose? - Ford Taurus Forum

The hose connection at the water pump pipe is accessible, but the manifold end is buried among a number of obstructions. I thought of purchasing ...

Thread: Replacing heater return hose (that attaches to expansion tank)

Hey guys. ... Traced the hose in behind the engine. My question is, can I replace it by removing the cabin air filter or does the intake manifold need to come off ...

Heater hose removal - Mustang Forums at StangNet

I disconnected the heater hoses at the intake manifold and block. I put rubber caps on the water ports. A friend was over and told me that it ...

Easy rear coolant hose replacement - Ranger-Forums

I did spray a little silicone spray in the hose so it would slip on the fitting easier. I was able to seat the hose on the fitting then I ...

Heater hose replacement - Volvo Forums

These couplings look like quick disconnect ones, but they're apparently anything but with plastic all around including fittings (that's what ...

Help with a DIY for removal of Heater core inlet hose - Bimmerfest

The hose above it is the "Return" hose (from the Heater Core back to Coolant Reservoir). It has a conventional spring hose clamp on the upper ...

5.4 2001 F150 Heater Hose leak - Community of Ford Truck Fans

Bad again....the hose to the heater pipe that runs under manifold can be impossible to remove with manifold on truck. I had to fight 25 min ...

How to remove heater hose from firewall. - Diesel Place

Removing heater hoses from firewall. I am planning to drain and flush my cooling system and while I have it drained I plan to replace all ...

Radiator Hose Connections? - IH PARTS AMERICA

The long hose is the return plumbing, it connects the top fitting on the heater core with the nipple mounted to the water pump housing.

Removing 1300 coolant hoses and bypassing heat flow in intake ...

turned the "Y" . I made a short "U" for the hose from the thermostat housing to the "Y". Now the straight part of the "Y" ...

Chevrolet 5.7 intake manifold removal/replace. | BobIsTheOilGuy

That coolant fitting looks likes its leaking or going to leak. They corrode, leak and then break off when trying to remove it. Its alot easier ...

Intake Manifold fitting - ClassicOldsmobile.com

Need to know what the part name is of the black fitting in the attached picture. The heater hose attaches to it. I tried to remove it from the ...

Removing heater hose clamp at back of engine??? More help ...

Once the clamp is off, twist the hose, or slice it lengthwise, then clean the metal for the new hose. On the heater core pipes, extra caution is ...

1998 F150 Heater Core Hose Replacement - F150online Forums

Yes, they both can be changed without removing the manifold. OldeIron's Avatar. OldeIron 01-03-2009 08:33 PM. Member. Thanks. I spent time ...

5.7 Heater Hose Quick Connect - MotorsForum

The 5.7 in my '99 Yukon has a heater hose that attaches to the intake manifold with a quick connect fitting which is leaking. Is this a problem that can be ...