Events2Join

Tighten or replace trans cooler line fitting at radiator


Radiator leaking coolant at a transmission fitting

Yes, I ended up replacing the the trans cooler fitting on the radiator. I drained the coolant below the fitting so that all of the coolant ...

First issue at 3k miles - transmission line came loose from the ...

Turns out when the dealer replaced both oil cooler lines ... lines in the fittings on both the transmission end and the radiator cooler end.

What is best way to repair a twisted transmission cooler line?

cut and replace. just a cooler line. no big deal. Like. 1.

Radiator or cooler line issue? - Chevrolet Cruze Forums

Install the oil cooler fitting (1) to the radiator and tighten to 20 N·m (15 lb ft). Install the transmission oil cooler hoses to the oil cooler ...

Radiator trans cooler question - The Ultimate 88-98 GM Truck Forum

Anyhow, install went fairly easy, but now I have a steady drip on the lower transmission cooler line when the engine is running. Looking at ...

Transmission cooler line connector fitting leaking - Ford Taurus Forum

... replaced the radiator for him. Just needed tightening. Trans cooler is inside radiator submerged in coolant. Just a rubber seal and brass ...

ATF leaking at radiator coolant line fitting on 2002 Envoy - GMTNation

Pretty much, screws into the tranny cooler, and the lines snap in under the E clips. The black clip is just a retainer for the E clips, so they ...

Tranmission line blew did it also damage my transmission

In the daylight I saw that the trans cooler line fitting had rusted out and was loose. ... Update: Got the radiator replaced, new coolant ...

HOW-TO replace transmission cooler lines (2007 G6 3.5L Auto)

1. Remove the lower engine splash shield under the radiator. It's held on by 4 plastic clips and 5 screws. 2. Remove the nut securing the cooler line bracket ...

transmission oil cooler lines - 96-2004 R50 Pathfinders - NPORA

So I wasted my day off yesterday trying to fix a PO f up. So the previous owner replaced the radiator and jerry rigged the auto trans cooler ...

Transmission Cooler Line Removal - Monte Carlo Forum

Need assistance with how to remove the transmission cooler line that connects to the radiator. Can't seem to break the bolt loose that screws ...

Really need some help re: transmission cooling lines.

While removing the radiator in order to add a new AC condenser, fan, and fan shroud, I found one of the fittings for the trans. cooling line ...

coolant leak at oil cooler fitting in radiator - Chevy Message Forum

The tank can be uncrimped, and seals replaced. You can try carefully tightening the nut but it may not help. If you tighten too much, it will crack the tank.

Spring clips on transmittion line to Radiator

Once the clip is installed put some light grease or oil into the fitting or on the outside of the line, and then push the cooler line into it ...

Coolant leak around oil cooler line fitting. - Blazer Forum

Remove that big washer and replace the rubber piece. You can pick one up from a radiator repair shop. When you replace the serrated washer DON'T ...

Transmission Cooler Line Connector - Community of Ford Truck Fans

I would remove the fitting from the radiator and replace it with a nipple similar to the end of the cooler line shown in your picture.

Cadillac Fleetwood Brougham tranmission cooler lines brass fitting ...

If you break the fittings loose the line will actually bend or twist slightly. If you squirt some penetrating oil on them and work back and ...

trans fluid to radiator fitting - The 1947 - 67-72 Chevy Trucks

I don't want to replace my lines ... "1/2" 20 STRAIGHT THREAD G1/4 is recommended as the fitting for the auto trans cooling lines in several of ...

Why is my transmission coolant line leaking from my radiator? - Quora

The transmission cooler in your radiator is cracked, requiring replacement ... line fittings near the radiator. If they are tight… then ...

oil cooler line replacement - EricTheCarGuy

Those lines goto the transmission and are for the transmission cooler. The job isn't that bad as mentioned above but it can be a little tricky getting the new ...